功能规格-标准（ functional specification- standard）.docVIP

Document MultiSmart Pump Station Manager Date November 1, 2012 Revision 6.00 MultiSmart version 3.0.3  Pump Controller Functions The pump controller shall provide user ready automatic control of pumps with an intuitive HMI interface. The pump controller shall contain pre-designed operational parameters that are selected and configured via the user interface (HMI). The minimum features available in the pump controller shall include: Pump control of up to 6 pumps; including pump grouping and pump alternation. Intelligent Hand-Off-Auto Control: Hand mode (semi-automatic, non-maintained manual mode), the pump switches off at the deactivation set point and then resets to Auto mode for the next pump run cycle. Hand mode (fully manual, maintained mode). To pump beyond the off (deactivation) set point, the Hand-Off-Auto button must be held down by the user for failsafe control. Level set point adjustment for pump activation, deactivation and station level alarms. Level device input capability shall include: 4-20mA analog signal, conductive probe or floats. Redundant level device input capability with automatic input fault control (input device switching). Selectable charge (fill) or discharge (empty) modes. Pre-configured station optimization features: Maximum pump off time Maximum pumps to run Maximum starts per hour Inter-pump start and stop time delays Maximum pump run time Blocked pump detection Well washer control capability Well clean out control capability Pump operation control (profile programming) capability “Locked level” alarm function to indicate a level device fault. User-defined % change within a specified time period Different set point values for low use or high use time periods (user defined) Pump alternation modes: Fixed lead pump assignment Normal alternation User defined alternation using N:1 ratio Run most efficient pump using N:1 ratio Alternation by the number of hours run or the number of