Paint.DOCVIP

CHAPTER 2 MATERIAL PROTECTION 20 GENERAL 200 General All painting works including surface preparation and shop priming shall be carried out in accordance with the Builder’s practice and the paint manufacturer’s recommendation based on the Specifications. Paint specifications shall be submitted to the Buyer for approval. The color of finish coats specified in the painting schedule shall be informed by the Buyer within one(1) month after the Contract but colors for each coat other than finish coat shall be in accordance with the paint manufacturer’s recommendation bearing in mind the color of finish coat. Technical supervision and guarantee during preparation and application shall be provided by the paint manufacturer, guarantee shall be provided by the Builder in accordance with the provisions of the Contract. No paint shall be applied to the following items or spaces unless otherwise specified. - Copper, brass, bronze, aluminium, aluminium alloy and other non-corrosive metals. - Wooden work in stores and lockers. - Polished fittings. - Inner surfaces of doubling plates and steel surface enclosed tightly. - Internal steel decks covered with deck covering. Paintings for the following items or spaces shall be carried out according to the Builder’s standard paint manufacturer. - Universal primer of outfitting. - Ultra heat resistant paint - Alkyd primer and alkyd F/C - Inside of masts, vent duct and posts. - Various seats. Paintings for the equipments and machineries, shall be carried out according to each manufacturer’s standard and the damaged part after installation shall be touched up with one(1) coat of finish paint of compatible kind in accordance with the Builder’s practice and acceptance of Buyer’s supervisor. 2 - 1 Where painting work for the part or spaces which are not specified and/or not described in detail in the Specification,