functional performance test（功能性能测试）.doc

Functional Performance Test Variable Frequency Drive (VFD)Pump Application Secondary Hydronic Pump Application Project: __________________________________ Date: __________________ Address: __________________________________ Commissioning Participants: Commissioning agent (CA): _______________________ of _____________________ EMS operator: _______________________ of _____________________ VFD technician: _______________________ of _____________________ HVAC technician: _______________________ of _____________________ Owners rep.: _______________________ of _____________________ Pumps ID:_____ _____ _____ ____ Chilled water (CHW) secondary, ___Hot water (HW) Design max.: Hp: ____ GPM: ______ Head _____ Ft VFD brand and model: ________________________________________________________ The following functional performance test is for a VFD controlling a variable flow hydronic system to a constant differential pressure (DP). A check-mark denotes acceptance or compliance. I. Design Intent and Documentation Verification ___ Review the design documents and the specifications. ___ Verify that the VFD ___description, ___specifications, ___technical and troubleshooting guide and the installation, ___programming record and ___balance report are on-site. From the design documents determine: Location for the DP measurement: _____________________________________________________________________ Control strategy for the pump:__________________________________________ _________________________________________________________________________ II. VFD Installation Differential Pressure Sensor Actual location of DP measurement____________________________________ The measurement should ideally be taken across the coil of the last branch. ____Complies? Pressure Offset (Po) Conversion: psi x 2.31 = ft H2O DP pump is being controlled to: _______feet [A]. Pressure rise across pump at design conditions (from