mobile cranes- elkhorn construction, inc（移动起重机——鹿角建设有限公司）.docVIP

Mobile Cranes Policy: Only designated personnel will be permitted to operate company cranes. All new or used cranes shall be inspected prior to initial use. The documentation shall include the date of the inspection, the signature of the person that is doing the inspection, and the identification of the equipment. This documentation shall be kept at the District/Area/Subsidiary/Project office on file. All controls for excessive wear and contamination. Operator’s must meet the physical qualifications, pass a physical, a written examination, understand and be able to use a load chart as well as calculate loads for the crane type. Referenced ASME B30.5 5-3.1(a). Daily or Before Use Inspections: Shall include the following and do not need to be documented. All controls for adjustment and proper operation. Any fluid or air leaks should be identified and repaired. Monthly inspections must be conducted and these inspections must be documented. A monthly inspection shall include the following: All controls for excessive wear and contamination. All safety devices for proper operation. Crane hooks that are deformed or cracked. Cranes will be taken out of service if a hook has: Cracks in the hook. A hook with a throat opening greater than 15% of normal. A hook with more than 10 degrees of twist. Item that must be taken out of service if: Wire Rope It has reeving that is in accordance with the manufacturer’s recommendations. The diameter of the rope to determine wear and insure that the rope will handle the specified load. A check for broken wires that may reduce the load capacity of the rope. A check for severe kinking, crushing, cutting or un-stranding of the rope. Electrical equipment for deterioration, dirt, moisture and proper operation. Deformed, cracked or corroded members of the crane structure. Loose bolts or rivets. Cracked or worn sheaves or drums. Worn, cracked or distorted parts such as pins, bearings, shafts