ppt课件-doereviewtemplate-advancedacceleratorgroup.pptVIP

MINOS detector NuMI Target: Today and Tomorrow Beam Parameters and Upgrade Path NuMI target How n beam is produced Different n spectra obtainedby moving target and 2nd horn m spectra moving off-axis( unoscillated, GEANT M.C. ) NuMI target types Low Energy Targetwill be used for MINOS NuMI Prototype Target M.E. style section used in beam test Target – Low Energy Version(Low Energy refers to neutrino spectrum, not beam power) Narrow – location checked by scanning beam across edge. Sense by: (i) charge (delta-rays) knocked out (wire connected to target) (called Budal) (ii) scattered beam into cross hairs ionization chamber (BLM) Target Temperature- lots of headroom Target dynamic stress?(Approximately linear with instantaneous protons) Budal for L.E. target Radiation Damage Any fall-backs in case of rapid radiation damage ?Factor of a few: Target Test Conditions Target Budal Monitorin test beam Target Upgradesummary Conclusion NuMI NuMI Outline: NuMI Beam Parameters Design Constraints Thermal and Stress Analysis Instrumentation Radiation Damage Target Tests Upgrade to 1.6 MW(+) NuMI beam design parameters: 0.4 MW beam power 120 GeV/c proton beam 4x1013 protons per 8.6 msec beam spill 1.87 sec repetition rate 1 mm RMS circular beam spot size Upgrade path considered to 1.6 MW (+) design: 120 GeV/c proton beam Double number of protons per spill Double repetition rate (higher repetition rate easier to handle than instantaneous) IHEP Protvino design team V.Garkusha, V.Zarucheisky F.Novoskoltsev, S.Filippov, A.Ryabov, P.Galkin, V.Gres, V.Gurov, V.Lapygin, A.Shalunov, A.Abramov, N.Galyaev, A.Kharlamov, E.Lomakin, V.Zapolsky FNAL design team J.Hylen, K.Anderson FNAL beam test J.Morgan, H.Le, Alex Kulik, P. Lucas, G. Koizumi Energy deposition calculations done with MARS Target construction done at IHEP MINOS on-axis: - Target in horn (L.E. configuration) Off-axis detector experiment probably prefers M.E. configuration (target