section283100-firedetectionandalarm（21页）.docVIP

This master should be used by designers working on Port of Portland construction projects and by designers working for PDX tenants (“Tenants”). Usage notes highlight a few specific editing choices, however the entire section should be evaluated and edited to fit specific project needs. SECTION 283100 - FIRE DETECTION AND ALARM GENERAL DESCRIPTION Install a complete point addressable and fully programmed fire alarm system to interface through the existing Siemens Building Technologies Apogee Life Safety 3 (ALS3) fire alarm panel with the FireWorks network. Performance of the added system shall meet all performance aspects of the existing Siemens ALS3 system. Work shall include but not be limited to: Edit or delete 1 and 2, as required. Providing UL-listed, electrically operated, electrically supervised, stand-alone fire alarm control panel with connection to the existing FireWorks network. Providing alarm silence switch in all new ALS3 panels to override alarm while testing water flow. Switch in silence position shall be monitored as a trouble alarm. Edit or delete the following subparagraph, as required. Providing voice evacuation amplifiers. Providing alarm initiating devices: manual pull stations, area smoke detectors, and duct detectors as required. Providing monitor modules and wiring (conduit, wire, etc.) required to power and/or interconnect devices supplied under other divisions, including: Sprinkler valve supervisory switches. Sprinkler valve flow switches. Edit or delete the following subparagraphs, as required. Fuel shut off switches. Loading bridge heat detectors. Automatic transfer switch. Sanitary lift station alarm. Revolving vestibules. Edit or delete the following subparagraph or any of its following items, as required. Providing detection devices, control, and/or monitor modules to: Signal HVAC system to shut down new air handling units. Interrupt power to magnetic locks at emergency exits. Signal HVAC system to release fire/smoke dampers. Prov