切片机预防性保养中.ppt

September 2006 Meyer Burger AG Preventive maintenance 预防性的维护 2010 当心!!! Take care!!! 当心!!! Take care!!! 当心!!! Take care!!! 当心!!! Take care!!! 当心!!! Take care!!! 当心!!! Take care!!! 1. 时间间隔 Interval 维护指导 Maintenance instruction 切割过程中 During cutting 每天，在每次切割 前 Daily before each cutting operation 每次切割后 After each cutting procedure 检查 Check 固定轴承和活动轴承的温度 Temperature of the fixed and moveable bearings - 线匝的切割线结构 Wire structure winding spool 清洁 Clean - 工件支承台 Workpiece support 检查 Check - 检查导轮的磨损情况 Check the wire guide rollers for wear 检查换向轮的校准情况和运行时间 Check the deflection rollers dor alignment and running time 清洁 Clean - 浆液斗 Slurry drawer - 浆液喷嘴 Slurry nozzles Cleaning the workpiece support  清洁工件支承台 Cleaning the slurry drawer 清洁浆液斗 2. 时间间隔 Interval 维护指导 Maintenance instruction 每周或机床长期停 用前 或运行 125 个小时 后。 Weekly or before longer shutdowns of the machine or after 125 hours 清洁 Clean - 管路清洁 Pipe cleaning - 切割区域和线匝 Cutting area and winder - 浆液过滤管 Slurry filter tub - 浆液过滤器 Slurry filter 检查 Check - 检查换向轮轴承 Check deflection roller bearings - 浆液过滤器 Slurry filter Pipe cleaning 管路清洁  Cleaning the cutting and winding area  清洁切割区域和绕线区域 3. 时间间隔 Interval 维护指导 Maintenance instruction Slurry tank - Empty the slurry tank completely. - Remove deposits in the tank, clean the slurry tank with water. - Refill flushing carrier fluid. - Connect all hoses including slurry nozzles. - Run the flushing carrier fluid for at least 2 hours. - Swivel pulleys of traversing devices and load cells must be cleaned well, so that the gap of 1 mm is free of dirt. - Empty the tank if flushing is completed. - Replace the slurry filter if necessary. Note: Flushing carrier fluid may be used several times 4. 时间间隔 Interval 维护指导 Maintenance instruction 每月，或运行 500 个小时后。 Monthly or after 500 hours 清洁 Clean - 测力轮 Load-measuring roller 检查 Check - 测力轮 Load-measuring roller - 球面座圈