1intelserverboards1200btsquickstartusersguide.docVIP

Intel? Server Board S1200BTS Quick Start Users Guide Thank you for buying the Intel? Server Board S1200BTS. The following information will help you integrate your new server board into a server chassis. The Intel? Server Board S1200BTS is designed for use with the Intel? Server Chassis P4000 series. For details on these chassis or to select a third party chassis, please visit /go/serverbuilder and /support/motherboards/server. Minimum Hardware Requirements To avoid integration dif?culties and possible board damage, your system must meet the following minimum requirements: ? Processor: Intel? Xeon? E3-1200 processors or the 2nd Generation Intel? Core? i3 processors, Intel? Xeon? E3-1200 V2 processors or the 3rd Generation Intel? Core? i3. ? Memory Type: 32 GB maximum with x8 ECC UDIMM (2Gb DRAM). ? Power: Minimum of 350 W with 3A of standby current, which meets the SSI EPS 5V speci?cation. Tools Required Fastener Identi?cation Guide Flat-blade screwdriver Phillips* screwdriver Anti-static wrist strap 1 Preparing the Chassis Installing the I/O Shield and Attach I/O Labels If using a non-Intel? server chassis, refer to the documentation that came with your chassis for preparatory steps. Observe normal ESD (ElectroStatic Discharge) procedures. Place your Intel? Server Chassis and Intel? Server Board on a ?at anti-static surface to perform the following integration procedures. Always touch the chassis frame ?rst, before reaching inside to install the server board, make server board connections or install other components. 2 Note: The I/O Shield and label installation procedures shown below apply to the Intel? Server Chassis P4000 series. When installing the server board into a reference chassis, refer to the reference chassis instructions. If you are not familiar with ESD (Electrostatic Discharge) procedures used during system integration, please see the Intel? Server Board S1200BT Service Guide, available on the Intel? Server Deployment Toolkit CD or a