TCS中英对照.docx

英文中文10GT PLANT OVERVIEW 电厂概述GT OPERATION燃机运行BLADE PATH/EXH TEMP叶片通道/透平排气温度READY TO START CONDITION允许启动条件CONTROL OIL控制油LUBE OIL润滑油VIB/BRG TEMP振动/瓦温FUEL GAS燃料气体EMERGENCY TRIP OIL紧急跳闸油AIR AND FLUE GAS风烟系统ST OPERATION汽机运行GT GEN.OPERATION MONITOR1发电机控制监视1VIM SWITCHVIM转换TCA COOLER转子冷却空气冷却器CONTROL BLOCK控制模块STEAM TURBINE MONITOR蒸汽轮机监视GT GEN.OPERATION MONITOR2发电机控制监视2H2 GAS FLOW氢气流量GT COMP BLADE WASH压气机叶片清洗GT GEN.H2 GASSEAL OIL发电机氢气及密封油STEAM FLOW 蒸汽流量GT GEN.TEMP MONITOR发电机温度监视CASING COOLING SYSTEM透平壳体冷却系统KEY SINGLE LINE机岛电气接线图（单线示意图）SYSTEM STATUS系统状态10GT OPERATION 燃机控制TURNING MOTOR RUN盘车电机运行READY TO START启动准备完成STARTING DEVICE RUNSFC装置运行FUEL GAS ON燃气供给START启动NORMAL STOP正常停机MAINT.STOP检修停机DUCT PURGE REQUEST烟道吹扫请求PURGING清吹中START MODE SELECT启动模式选择NORMAL正常模式SPIN高盘模式ALR MODE SELECT自动负荷调整模式选择ALR ON自动负荷调整模式启动ALR OFF自动负荷调整模式退出OPERATION SELECT操作选择COORDINATION ON协调控制选择COORDINATION OFF协调控制退出OPERATION MODE SELECT运行模式选择GOVERNOR转速控制LOAD LIMIT负荷限制FUEL GAS CALORIE METER燃气热值计算仪SFC SELECTSFC选择AGC AND PRIMARY FREQUENCY REGULATIONAGC和一次调频AGC ONAGC投入AGC OFFAGC退出PRIM.FREQ.RUGULATION ON一次调频投入PRIM.FREQ.RUGULATION OFF一次调频退出FLAME #18/19 ON#18、#19有火焰检测信号LP BLV CLS低压防喘阀关位MP BLV CLS中压防喘阀关位HP BLV CLS高压防喘阀关位RTD SPEED 可并网转速GEN.ON发电机并网CONTROL MODE SELECTION控制模式选择BP TEMP叶片通道温度控制模式EXH TEMP 透平排气温度控制模式FUEL LIMIT燃料限制模式GT COMP ON-LINE BLADE WASH SELECT压气机在线水洗控制CPFM燃烧室压力波动监视ADVANCED CPFM AUTO ADJUSTMENT CONTROL先进CPFM自动调整控制GAS RESET天然气复位OIL RESET油燃料复位EXCLUSION限制MARGIN LOW裕量低LOAD HOLD负荷保持GT LOAD OPERATION燃机负荷控制ALR SET 自动负荷调整设定GOVERNOR SET转速调节器设定LOAD LIMIT SET负荷限制设定OVER SPEED TRIP TEST超速跳闸试验OST TEST ON/OFF超速跳闸试验启动/结束MAIN/BACKUP EOST SELECT主/后备电超速模式选择10GT READY TO START CONDITION 准备启动条件AUX READY辅机准备AUX RUN辅机运行IGV CLOSE压气机入口导叶关闭GT SPIN PERMISSIVE(HRSG CONDITION)燃机高盘允许（锅炉侧条件）LUBE OIL PRESS OK润滑油压正常AIR FILTER NORMAL进气滤网正常COMB.BYPASS VLV OPEN燃烧室旁路阀开位SFC READYSFC准备好CONTROL OIL PRESS OK控制油压正常GENERATOR READY发电机正常GEN.H2 READY发电机氢气系统正常INST AIE PRESS OK仪用气压力正常CONDENSER VACUUM NORMAL凝汽器真空正常AUX.BOILER OUT PRESS OK辅助蒸汽供给压力正常GT TRIP