POTABLE WATER AND GREY WATER TRUCKS US 饮用水和灰水卡车我们.pptVIP

* A bottom drain shall be provided to facilitate complete discharge of water during sanitation procedures. * Tanks shall be filled using a system that prevents backflow of water from the vehicle tank to the source. Either of the following methods may be used. * Approved double check valve on the direct filling connection to the tank. * Overhead filling through a hatch opening at the top of the tank. The filling spout must not be allowed to intrude into the tank further than two diameters of the filling pipe above the highest water level that is possible when the tank is filled. If an overhead filler pipe is mounted on the vehicle when not being used for filling, this pipe shall be capped at each end with threaded or clamped caps, and tethered to the fittings at the ends of the filler pipe. * Only water transfer pumps that can be readily disassembled to demonstrate the condition of the impeller and impeller chamber shall be used. * Food grade pumps, marked with the appropriate A-3 marking embossed in a metallic housing. Constructed from stainless steel, plastic, brass, smooth finished aluminum, or other food grade materials. Water contact surfaces, including seals, bearing, and lubricants must be constructed from food grade materials and must be smooth, nonporous, and corrosion resistant. Acceptable food grade lubricants are usually white or pastel colored. * Pumps that are food grade will have a label on them showing the A3. * Pumps that are constructed of non-porous materials, i.e. polished aluminum, stainless steel, or plastic, that are used for domestic water transfer. All water contact surfaces including seals, bearings, and lubricants must be constructed of materials suitable for its intended use. Any pump that does not have the National A-3 designator factory embossed into its housing, must have a signed (Certification Form) from the Contractor’s respective County Health Department designating said pump as a potable water pump. * * Hoses shall hav