PowerPointprsentation cabelconPowerPoint #公关代表 cabelcon 230.dk.pptVIP

* * * * * CorningCabelcon * CorningCabelcon * CorningCabelcon * To begin with – we need some tools… Cablecutter Cabelcon RG11 Rotary Stripper Mounting tools Compression tool Please read the instructions before using the tools! Let’s start to work… First step is to cut your cable using a proper cable cutter. Strip your cable… Insert the cable into the cable stripper as shown… Attention: Please make sure to adjust the tool blades for your cable dimensions before using it for the first time! Please read instructions supplied with the tool. Screws for adjustment of blades Hex tool for adjustment Strip your cable… Turn the stripper clockwise 4-5 times… Strip your cable… - Press the tool jaws together around the cable and pull to remove the scraps… Strip your cable… Optional: You can check the stripping dimensions against the guide printed on the connectors 6,5 + 6,5 mm (?” + ?”) Prepare your cable… Fold exposed braid over the jacket. Leave the inner foil attached to the dielectric and make sure that the foil is undamaged and smooth. For ”Quad shield”, ”Tri shield” and ”Super shield” cables: Remove the outer braid and foil only. Fold back the inner braid. Push the connector over the foil and allow the support mandrel to slide between the foil and braid… Mount the connector… Press and turn until the pin is pushed forward and visible as shown. Mount the connector… Mounting tools can be used to ensure a better grip on both connector and the cable… Compress the connector… 1) Insert your connector/cable into the tool with the tool handle in open position… 2) Apply a downward pressure on the cable to allow the split jaws to secure the cable… Click! Compress the connector… - and close the tool handle completely insuring the connector sleeve is fully compressed. Open the tool - press the outside split-jaw tabs and pull out the connector assembly… Take out the connector… CX3 RG7/11 Compression completed! The inner co