Using Alice rferro用爱丽丝 rferro.pptVIP

* Now I have dragged a penguin to the scene. I then clicked on done since I am finished moving objects for the moment. * I now dragged two methods to my world. First the penguin is going to wing_flap 2 times and then it is going to jump 2 times. If I click on Play, I can see it happen. Note the penguin glide is on a tab because I dragged it over and then changed my mind. I decided to wait to put it on. * This shows the penguin after I clicked play. It flapped and jumped and now it has stopped. I will now click stop so I can continue planning. * Now I have dragged over glide. * The glide has predefined instructions that are done together to make the penguin glide. They are shown in this screen. Notice that when the penguin glides, it glides 5 meters. This takes it off the screen. I adjusted that to 1 meter as shown on the next slide. * You can see I changed the move to 1 meter. This shows the end of the glide. When I watch the penguin glide forward for 1 meter I can also see that he flaps his wings. This is grouped together as shown above. * You can see that the penguin does all of the activities that are defined as part of the glide. * I decided that when the penguin jumped it was jumping too high so I have changed the height to 1. * At the end of the glide the penguin is facing down, so I am going to make him stand. These are some of the choices I can make as I do that. * When I test this, the penguin is ending up looking up. I don’t like this view so I am going to change it. * I am happier with the head now. Note that I periodically do a file save. If I don’t Alice will prompt me every few minutes. * Now I have decided that I want the penguin to do two things together, so I dragged up the Do together and then I dragged over waling and wing flapping. * Now I want to turn the penguin and move him forward toward the center of the screen. * The penguin has now turned around – next will code a forward mothion. * After the penguin turned .5 revolutions,