ANALIGNMENTOFJ-PARCLINAC.pdfVIP

Proceedings of the 2nd Annual Meeting of Particle Accelerator Society of Japan and the 30th Linear Accelerator Meeting in Japan (July 20 - 22, 2005, Tosu Japan) AN ALIGNMENT OF J-PARC LINAC Takatoshi Morishita1,A), Hiroyuki Ao A), Takashi Ito A), Akira Ueno A), Kazuo Hasegawa A), Masanori Ikegami B), Chikashi Kubota B), Eiichi Takasaki B), Hirokazu Tanaka B), Fujio Naito B), Kazuo Yoshino B) A) Japan Atomic Energy Research Institute, 2-4 Shirakata-shirane, Tokai-mura, Naka-gun, Ibaraki, 319-1195 B) High Energy Accelerator Research Organization, 1-1 Oho, Tsukuba-shi, Ibaraki, 305-0801 Abstract J-PARC linear accelerator components are now being installed in the accelerator tunnel, whose total length is more than 400 m including the beam transport line to 3GeV synchrotron. A precise alignment of accelerator components is essential for high quality beam acceleration. In this proceeding, planned and ongoing alignment schemes for the installation of linac components and watching the long term motion of the building are described. Markings are placed on the floor, which act as a reference for the initial alignment at the installation. For a straight line alignment, the wire position sensor is placed on the offset position with respect to the beam center by a target holder. The hydrostatic levering system is used for watching the floor elevation over the long period. J-PARC リニアックにおけるアライメント １．はじめに これらを地上から直接見通して、３GeVシンクロト ロンとの相対位置測量を行った。その結果、相対誤 J-PARC リニアック[1]では、加速器機器のインス 差は入射角度およそ0.00065°水平方向約3mmであり トールが2005年4月より開始された。それに先立っ [4