不锈钢平面的半固着磨粒加工.pdfVIP

2008年12月 第6期总第168期 金刚石与磨料磨具工程 Diamond＆Abrasives Engineering Dee．2008 No．6 Serial．168 文章编号：1006—852X(2008)06—0026一05 不锈钢平面的半固着磨粒加工’ 赵萍1 王志伟2俞冬强2袁巨龙2’3 (I．浙江工业大学教育科学与技术学院，杭州310014) (2．浙江T业大学机械制造与自动化教育部重点实验室，杭州310014) (3．湖南大学围家高效磨削工程技术研究中心长沙410082) 摘要以马氏体不锈钢SUS 440C为加工对象，使用们000碳化硅磨粒进行半圆着磨粒和游离磨粒加 工。半固着磨具与工件的接触采用面一面接触方式，半固着磨具使用SSB结合刺，磨粒重量浓度为60％， 孔隙率为70％。游离磨粒加工中研具材料为球墨铸铁。两种加工方法中，加工开始10 rain后工件表面 粗糙度迅速由Ra0．2“m左右降低至Ra0．07 Ixm以下，加工30rain后工件表面质量趋于稳定。工件表 面质量主要取决于磨粒粒度与D．r-时间，加工载荷与磨具／研具转速的影响较小。半固着磨粒加工可获 得比游离磨粒加工更高的表面质量。 关键词半同着磨粒加工；游离蘑粒加工；碳化硅磨料；抛光 中图分类号TG74 文献标识码A Semi-bonded abrasive machining for stainless steel plane finishing Zhao Pin91 Wang Zhiwei2 Yu Dongqian92 Yuan Julon92-3 (1．College of Education Science and Technology，Zhejiang University of Technology，Hangzhou 3 10014，China；) (2．MOE研Laboratory of Mechanical manufacture and Automation， Zhejiang University of Technology，Hangzhou 3 10014，China；) (3．National Engineering Research Centerfor High Efficiency Grinding， ttunan University，Changsha 410082，China) Abstract Mechanical polishing experiment was carried out on martensitic stainless steel，SUS 440C，by semi—bonded and loose abrasives machining technology using green silicon carbide gIjts with size of#3000．The contact mode of workpiece and semi—bonded abrasive plate is plane—plane，the bonding agent is SSB，the concentration of abrasives grits is 60 wt％，and the porosity is 70％．The material of lapping board used in loose abrasives machining is ductile cast iron．During semi-bonded or loose abrasive machining，the 9,urface roughness of workpieces decreases from nearly Ra 0．2斗m to lower than Ra 0．07 txm after 10 minutes processing，and lends to the minimum value after 30 minutes processing．It is found that the machined surface quality mainly depends on the size of abrasive particles and processing time．On the contrary，the effect of the load and the rotating speed of semi·bonded abrasive plate or cast iron lapping board are insignificant．The ·国家自然科学基金资助项目 万方数据 第6期 赵萍等：不锈钢平