- 8
- 0
- 约5.81千字
- 约 5页
- 2017-03-28 发布于广东
- 举报
阻抗复合消声器的动态优化及特性分析.pdf
第八届全国振动理论及应用学术会议论文集,上海,2003 年 11 月
阻抗复合消声器的动态优化及特性分析
周新祥 马宝丽
( 鞍山科技大学,辽宁鞍山 114002)
摘 要: 对 VW—0.22/7—B 型空压机的噪声源测试分析,确定其空气动力性噪声最强。从机器本身结构
及特性考虑,主动噪声控制难以达到环境噪声要求的情况下,则势必采取被动噪声控制措施。在空压机进气
口安装一种阻抗复合消声器,该消声器采用动态优化设计方法,并采用有限元动力计算,了解消声器的动态
特性,以期获得动态特性好、消声量大的优质消声器。
关键词: 动态优化; 阻抗复合; 消声器; 有限元; 动态特性
Dynamic optimal and characteristics analysis
of the impedance compound muffler
ZHOU Xin-xiang MA Bao-li
( Anshan University of Science and Technolgy, Anshan Liaoning 114002 )
Abstract: An aerodynamic noise is confirmed to be the strongest one according to the test and analysis of the frequency
spectrum of the noise from VW—0.22/7—B Air Compressor from the consideration to the machine itself structure and
characteristic. Noise initiative control of them can’t be met so noise passive control must be used . At the air compresser
inlet, impedance compound muffler is installed this muffler is got by the methed of the optimal. After thoroughly
understanding of the dynamic characteristics of the structure,limited unit dynamic computing methed is used so that we can
design noise elimination device with large noise elimination.Perfect dynamic characteristics and reasonable structure quickly.
key words: Dynamic optimal; impedance compound; Muffler; Limited unit; Dynamic characteristics
1 空压机噪声源测试分析
全无油空压机是国家替代进口的新产品。本研究选用 VW—0.22/7—B 无油空压机主要性能参数
基金资助:鞍山市科委重点技术系列项目
作者简介:周新祥(1955-),男,教授
1
为:流量为 0.22m3 / min ; 两进气口为圆截面,内径为 23mm;压力为 7 ×105 Pa ;转数为 945r /min ;
功率为 2.2Kw ;缸数为 2 缸单作用。驱动电机为 Y100L1—4,功率为 2.2Kw;电流为 50(A);转
数为 1430r/min;电压为 380V;频率为 50Hz。
空压机工作运转时,进口直接吸空,出口与管路相连。参照国家有关小型机器的测量规定,测点的
水平距离为 1m,距地面为 0.5m。通过各测点数据分析,空压机进气口噪声最强烈见表 1(其它测点数
据未列)。同时,对噪声信号进行自功率谱分析处理。
由测试及频谱分析知,该型空压机的噪声源主要有空气动力性噪声、机械噪声和电机噪声。空
气动力性噪声最强,该空压机进气口噪声尤为强烈。从表 1 中看出,它的噪声频谱较宽,从 250~16KHz
都超出 NR55 的规定值,A 声级为 81dB。从噪声信号处理自功率谱分析看出,在 189、252、472.5、
504Hz 处的能量较大,由此看出,空压机进气噪声的谐频较突出,最强发生在 504Hz 处。
表 1 空压机噪声倍频程声压级(dB)与 A声级(dB)
Table 1 Octave (Hz) Sound Pressure Level and a Sound
您可能关注的文档
最近下载
- 制造业信息化战略规划实施与优化-PDM.docx VIP
- 那智不二越机器人flexgui toolbox操作说明书.pdf VIP
- 智慧工厂-智慧工厂解决方案.docx VIP
- 高中化学解题方法归纳:和量法.doc VIP
- 译林牛津新版高中英语(必修1-3)单词表.pdf VIP
- 包装有限公司分切机安全风险分级清单.docx VIP
- 重庆市西南大学附属中学2025届高三下学期二诊模拟考试物理试卷 含解析.docx VIP
- 【高中英语】《星火英语同步词汇》抗遗忘速记手册.docx VIP
- 成都市锦江区2026届初三一诊(暨期末考试)数学试卷(含答案).docx
- 三坐标 培训教程.pptx VIP
原创力文档

文档评论(0)