交换机功能配置.doc

交换机功能配置 配置 配置2层EtherChannel 配置SW1 sw1(config)#int range f0/23 - 24 sw1(config-if-range)#channel-group 12 mode desirable 说明：在接口F0/23-24下选用PAGP配置EtherChannel 配置SW2 sw2(config)#int range f0/23-24 sw2(config-if-range)#channel-group 12 mode desirable 说明：在接口F0/23-24下选用PAGP配置EtherChannel 查看EtherChannel sw1#show etherchannel summary Flags: D - down P - in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 U - in use f - failed to allocate aggregator u - unsuitable for bundling w - waiting to be aggregated d - default port Number of channel-groups in use: 1 Number of aggregators: 1 Group Port-channel Protocol Ports ------+-------------+-----------+------------------------------------------ 12 Po12(SU) PAgP Fa0/23(P) Fa0/24(P) 说明：可以看到，已捆绑的接口为2层接口，并且所有物理接口都工作在EtherChannel下。 在port-channel接口下配置接口 sw1(config)#int port-channel 12 sw1(config-if)#switchport mode access sw1(config-if)#switchport access vlan 10 说明：port-channel接口下将接口划入VLAN。 查看port-channel接口MAC地址 sw1#sh int f0/23 FastEthernet0/23 is up, line protocol is up (connected) Hardware is Fast Ethernet, address is 007d.618d.0317 (bia 007d.618d.0317) sw1#sh int f0/24 FastEthernet0/24 is up, line protocol is up (connected) Hardware is Fast Ethernet, address is 007d.618d.0318 (bia 007d.618d.0318) sw1#sh int port-channel 12 Port-channel12 is up, line protocol is up (connected) Hardware is EtherChannel, address is 007d.618d.0318 (bia 007d.618d.0318) 说明：port-channel使用了接口F0/24下的MAC地址，说明接口F0/24先工作正常。 配置3层EtherChannel (1)配置SW1 sw1(config)#int range f0/23 - 24 sw1(config-if-range)#no switchport sw1(config-if-range)#channel-group 12 mode active sw1(config)#int port-channel 12 sw1(config-if)#ip address 10.1.1.1 255.255.255.0 说明：配置3层EtherChannel，需要先将物理接口变成3层接口后，才能正常配置，IP地址必须在port-channel下配置。 配置SW2 sw2(config)#int range f0/23 - 24 sw2(config-if-range)#no switchport sw2(config-if-range)#channel-group 12 mo active sw2(config)#int po