LTESAE网路架构与元件-mbat.ppt

* 大綱 課程目標 LTE之簡介與演進 LTE/SAE網路架構 RRC Connection Procedures LTE/SAE元件 附錄：台灣的LTE現況 * RRC Connection Procedures RRC的狀態分為 RRC_IDLE 與 RRC_CONNECTED IDLE狀態下UE不會被分配到無線資源 需要傳輸資料時， UE 轉入 RRC_CONNECTED程序以 取得無線資源 以下介紹四種RRC控制程序 RRC Connection Establishment RRC Initial Security Activation RRC Connection Reconfiguration RRC Connection Release RRC 狀態： RRC_IDLE 變成 RRC_CONNECTED RRC Connection Procedures－RRC Connection Establishment UE E-UTRAN RRC連線成功 RRCConnectionRequest RRCConnectionSetup RRCConnectionSetupComplete * RRC Connection Procedures－RRC Connection Establishment (Cont.) UE E-UTRAN RRC連線失敗 RRCConnectionRequest RRCConnectionReject RRC 狀態維持在RRC_IDLE * RRC Connection Procedures－RRC Initial Security Activation UE E-UTRAN SecurityModeCommand SecurityModeComplete 完成UE與eNB之驗證 後可做保密性及資料完整性等安全防護 * RRC Connection Procedures－RRC Connection Reconfiguration UE E-UTRAN RRCConnectionReconfiguration RRCConnection-ReconfigurationComplete 可設定Handover等各種無線相關控制 * RRC Connection Procedures－RRC Connection Release UE E-UTRAN RRCConnectionRelease RRC 狀態： RRC_CONNECTED變成RRC_IDLE * 大綱 課程目標 LTE之簡介與演進 LTE/SAE網路架構 RRC Connection Procedures LTE/SAE元件 附錄：台灣的LTE現況 * LTE/SAE元件－System Architecture Evolution 基於GPRS核心網路(General Packet Radio Service Core Network)的演進 演進理念 加強 Packet Switched Technology 以處理快速成長的 IP Traffic Higher Data Rates Lower Latency Packet Optimized System 更高Throughput Fully IP Based Network Simplified Network Architecture Distributed Control * LTE/SAE元件－System Architecture Evolution (Cont.) 與GPRS核心網路之不同點 架構更簡化 All IP網絡 支援更高的吞吐量之無線接入網路 支援更低的延遲之無線接入網路 支援多重異質性網路的互通 LTE/LTE-A Air Interface UMTS Air Interface Non-3GPP (WiFi, WiMAX等) * LTE/SAE元件－Evolved Packet Core SAE的主要組成部份為EPC (Evolved Packet Core?) EPC又被稱為SAE核心 (SAE Core) EPC之作用與GPRS網路相似 通過Mobility Management Entity (MME)、Serving Gateway (S-GW)和Packet Data Network Gateway (PDN-GW或P-GW)等子元件實現 * LTE/SAE元件－Evolved Packet Core (Cont.) Main Logical Nodes Mobility Management Entity (MME) Serving Gateway (S