51-1010 Two-Throat Instr.pdfVIP

Installation Instructions for SS? TWO THROAT Carburetor (Serial #E1190 Higher) SS ? Cycle, Inc. 235 Causeway Blvd. La Crosse, Wisconsin 54603 Phone: 608-627-1497 ? Fax: 608-627-1488 Technical Service Phone: 608-627-TECH (8324) Technical Service Email: sstech@ Website: Instruction Sheet 51-1010 Revised 4-4-06 Copyright?, 2002, 2006 by SS Cycle, Inc. All rights reserved. Printed in the U.S.A. Because every industry has a leader SAFE INSTALLATION AND OPERATION RULES: Before installing your new SS part it is your responsibility to read and follow the installation and maintenance procedures in these instructions and follow the basic rules below for your personal safety. l Gasoline is extremely flammable and explosive under certain conditions and toxic when inhaled. Do not smoke. Perform installation in a well ventilated area away from open flames or sparks. l If motorcycle has been running, wait until engine and exhaust pipes have cooled down to avoid getting burned before performing any installation steps. l Before performing any installation steps disconnect battery to eliminate potential sparks and inadvertent engagement of starter while working on electrical components. l Read instructions thoroughly and carefully so all procedures are completely understood before performing any installation steps. Contact SS with any questions you may have if any steps are unclear or any abnormalities occur during installation or operation of motorcycle with a SS part on it. l Consult an appropriate service manual for your motorcycle for correct disassembly and reassembly procedures for any parts that need to be removed to facilitate installation. l Use good judgement when performing installation and operating motorcycle. Good judgement begins with a clear head. Dont let alcohol, drugs or fatigue impair your judgement. Start installation when you are fresh. l Be sure all federal, state and local laws are obeyed with the installation. l For optimum performance and s