MAX1534ETE+T;MAX1534ETE+;中文规格书,Datasheet资料.pdf

General Description The MAX1534 is a high-efficiency, triple-output power supply for keep-alive (always on) voltage rails. The 500mA buck regulator with an internal current-limited 0.5? PMOS steps down the battery or wall adapter supply rail to a fixed 5V or an adjustable output voltage. Two integrated low-voltage linear regulators follow this output and provide two independent preset output volt- ages of 3.3V and 1.8V, or adjustable output voltages. The buck regulator utilizes a peak current-limit, pulse- frequency modulation (PFM) architecture for highest light-load efficiency to conserve battery life. High switching frequencies (up to 200kHz) allow the use of tiny surface-mount inductors and output capacitors. Operation to 100% duty cycle minimizes dropout volt- age (250mV at 500mA). The low-dropout linear regulators use an internal P-channel metal-oxide (PMOS) pass transistor to mini- mize supply current and deliver up to 160mA each of continuous current. The MAX1534 includes a power-OK (POK) signal that indicates all outputs are in regulation. The 4% accurate threshold of the SHDN input permits its use as a low- battery detector. The MAX1534 is available in a small 16-pin thin QFN (4mm ? 4mm) package, occupying 33% less board space than discrete solutions. Applications Features  One Switching and Two Linear Regulators  Switching Regulator +4.5V to +24V Input Voltage Range Over 95% Efficiency Up to 500mA Output Current Up to 200kHz Switching Frequency Fixed 5V or Adjustable Output Voltage Internal 0.5? PMOS Switch 100% Maximum Duty Cycle for Low-Dropout Operation  Two Low-Dropout Linear Regulators Up to 160mA Output Current (Each) 3.3V/Adj Output Voltage for OUT1 1.8V/Adj Output Voltage for OUT2  ±1.5% Accurate Output Voltage  ±4% Accurate Shutdown for Low Battery Detection  Thermal Shutdown Protection  POK Output  1mW Typical Standby Power M A X 1 5 3 4 High-Efficiency, Triple-Output, Keep-Alive Power Supply for Notebook Computers _____________________