Water and Oil Sending Unit Kits.docxVIP

WATER AND OIL SENDING UNIT KITSPURPOSEOF KITThese kits provide electronic sending units for connection to remote gauge panels used on Onan? generator sets with meters on the front panel. Qualified models are listed below under Applicable Generator Sets.Read these instructions completely and become familiar with all safety warnings, cautions and procedures before starting the installation.For personal safety and prevention of equipment damage, only qualified personnel should install these kits. Use the following procedure for kit installation.APPLICABLE GENERATOR SETSThe sender kits for remote meter panels or set mounted gauge panels are configured as shown below:Kit TypeGenset300-5040Neg. Grnd. MDKAA, MDKAB 12V OR 24V MAKAD,MDKAE MDKAF,MDKAL MDKUB,MDKWB 300-5041 Isolated Grnd.MDKAA, MDKAB 12V OR 24VMAKAD,MDKAEMDKAF,MDKALMDKUB,MDKWBNote that certain steps of the installation procedure are different for each kit and generator set. The applicable set is called out in these cases. TOOOLS NEEDEDHi Temp Thread SealerWrenchesDrain panOnan is a registered trademark of the Onan Corporation.Installation or service manual or the DC Wiring DiagramSAFETY PERCAUTIONSBefore beginning this installation:The generator set must be shut off, and disabled by disconnecting the negative battery cable.Check to see that you have the correct schematic and wiring diagram for the generator cable.! WARNING Accidental starting of the generator set can cause severe personal injury or death. Disconnect the starting battery cables (negative [-] cable first) before starting the installation.MKDAA,MKDAB and MKDAL INSTALLATIONTemperature Sender (3/8” external thread)Disconnect the generator set negative (-) battery cable. Do not reconnect the battery until this kit is completely installed.! WARNING Ignition of explosive battery gases can cause severe personal injury. Do not smoke. Wear goggles and protective rubber gloves and apron when servicing batteries. Allow the engine to