NJG1130KA1_E.pdfVIP

NJG1130KA1 - 1 -Ver.2007-06-13 GPS LOW NOISE AMPLIFIER GaAs MMIC
GENERAL DESCRIPTION
PACKAGE OUTLINE NJG1130KA1 is a low noise amplifier GaAs MMIC designed for GPS application at the 1.575GHz. The LNA offers excellent low noise figure, high linearity and low current consumption. Two stage amplifier and ESD protection circuit are integrated in the IC to achieve very high gain and high ESD tolerance. An ultra-small and ultra-thin package of FLP6-A1 is adopted.
FEATURES  Low voltage operation +2.85V typ.  Low current consumption 5.0mA typ.  High gain 29.0dB typ. @ f=1.575GHz  Low noise figure 0.65dB typ. @ f=1.575GHz  1dB gain compression output power +11.0dBm typ. @ f=1.575GHz  High output IP3 +14dBm typ. @ f=1.575+1.5751GHz, Pin=-35dBm  Ultra-small ultra-thin package FLP6-A1 (Package size: 1.6x1.6x0.6mm)
PIN CONFIGURATION Note: Specifications and description listed in this datasheet are subject to change without notice. (Top View) Package Orientation Mark 4 5 6 AMP AMP 3 2 1 NJG1130KA1 Pin Connection 1. RF OUT 2. GND 3. VDD 4. RF IN 5. GND 6. GND NJG1130KA1 - 2 -
ABSOLUTE MAXIMUM RATINGS Ta=+25°C, Zs=Zl=50ohm PARAMETERS SYMBOL CONDITIONS RATINGS UNITS Drain Voltage VDD 5.0 V Input power Pin VDD=2.85V +15 dBm Power dissipation PD on PCB board, at Tjmax=150°C 170 mW Operating temperature Topr -40~+85 °C Storage temperature Tstg -55~+150 °C
ELECTRICAL CHARACTERISTICS GENERAL CONDITIONS: VDD=2.85V, freq=1.575GHz, Ta=+25°C, Zs=Zl=50ohm, with application circuit PARAMETERS SYMBOL CONDITIONS MIN TYP MAX UNITS Operating voltage VDD 2.5 2.85 3.3 V Operating current IDD RF OFF - 5.0 8.5 mA Small signal gain Gain 26.0 29.0 31.5 dB Noise figure NF Exclude PCB connector losses (0.10dB) - 0.65 0.95 dB 1dB gain compression output power P-1dB(out) +5.0 +11.0 - dBm 3rd order output intercept point OIP3 f=