BIS_C-600调试.pdf

利用实验室现有 设备进行RFID 的 读写实验。 实验对象： CPU模块 Siemens CPU 315- 2PN/DP 串口通讯模块 CP340 RFID识别处理器 BIS C-600-007-…- 00-KL1 编码块 BIS C-104-11/A 24V 串口 电缆 PLC CP340 处理器 编码块 为设置BALLUFF BIS C600串口通讯参数， 需要安装BALLUFF BIS Configuration Software 上图为BALLUFF RFID BIS C-600 RS232串口参数设置 PC serial port 24V 串口（可使用 RS232/USB） 处理器 通讯口设置 1.选择Option-Port 2.选择对应通讯口 3.点击OK 1.选择对应的处理器 2.选择Online-Initialize, 连接处理器 连接处理器 3.设置串口通讯参数 参数注释： Baud rate:单位时间内载波 参数变化的次数,以“波特 每秒”（Baud per second） 为单位 Parity:表示给定位数的二进 制数中 1 的个数是奇数还是 偶数的二进制数 串口设置 4.设置协议类 型 参数设置 参数注释 CT-Present on RTS The parameter CT-Present on RTS (corresponds to the LED indicator Data carrier Present on the BIS C- 6_0 housing) can be used to allow the PC to check CT-Present using a hardware signal. You can connect the RTS signal, for example, to the free input RI (Ring Indicator) of the PC as this is only used with Modem operation. Direct data transmission Each time a data carrier is recognized, the data will be read out depending on the configuration and output to the interface. With this setting the read command in the dialog mode is superfluous. Dynamic Mode This function switches off the error-message No data carrier present, i.e.: - In dynamic mode, a read or write telegram is stored until a data carrier enters the Working range of the corresponding read/write head. - Without dynamic mode, a read or write telegram is acknowledged with an error message NAK 1 if there is no data carrier present in front of a read/write head; the processor goes into the ground state. 参数注释 CT-Present on Output 1 If CT Present is selected for Output 1, the LED message Data carrier Present is also output on Output 1. In this way the presence of a data carrier can be directly verified as a digital hardware signal. Process Outputs if CT Present The output functions are normally processed only after a read command. But since data carrier recognition is also an automatic tag read (reads first page, ei