光伏阵列及汇流箱设计论文40论文41.docVIP

PAGE   PAGE \* MERGEFORMAT 1 (此文档为word格式，下载后您可任意编辑修改！) 毕业设计(论文) 光伏阵列及汇流箱设计 二〇一三年五月二十四日 PAGE \* MERGEFORMATIII 摘要 当今世界，随着生物能源的频频告急和环境的日益恶化，发展新的可持续的绿色的能源已经成为大势。而在众多新能源之中，太阳能因为储量巨大、安全、清洁以及较少受地理和气候因素限制而倍受青睐。由于单体光伏电池的输出电压、电流和功率都很小，不能满足作为电源应用的要求，为了提高输出功率，需要多个单体电池合理的串、并联后封装成电池组件。太阳能本身是一种低密度的平面能源，需要用大面积的太阳能电池来采集。所以在需要更大功率的场合，需要将多个组件组成方阵，以提供数值更大的输出电流、电压。为了节约电缆，简化系统结构，提高可靠性和可维护性等原因，实际安装中需要把多个方阵的输出电缆先进行并联后（一级汇流）通过汇流箱再输入到逆变器（二级汇流），而不是直接把所有方阵电缆直接接入逆变器。 本文第一章介绍了太阳能产业的意义和目的，国内外光伏产业的现状和未来我国发展光伏产业的前景。在第二第三章介绍光伏发电的基本原理，以及高度角、方位角等安装参数的计算。并着重探讨了光伏汇流箱的作用原理和基于ATmega16单片机的光伏汇流箱相关硬件软件设计。 关键词：太阳能 光伏发电 汇流箱 原理； Design of the PV array and the solar photovoltaic junction box Abstract Todays world, with frequent emergency bioenergy and environmental deterioration, the development of new sustainable green energy , and less affected by geographical and climatic factors limit the favorites. As single photovoltaic cell output voltage, current and power are very small, can not meet the requirements of the application as a power supply, in order to improve the output power, to a plurality of series of cells reasonable, in parallel battery components packaged. Solar plane itself is a low-density energy, and require large-area solar cells to collect. Therefore, where more power is required, several components need to be square in order to provide greater output current value and voltage. In order to save the cable, simplifying the system structure, improve reliability and maintainability and other reasons, the actual installation requires a plurality of the first phalanx of the output cables be connected in parallel (a bus) through the combiner box and then input to the inverter (two convergence level), rather than all the cable directly to the matrix inverter. The first chapter describes the meaning and purpose of the solar energy industry, domestic photovoltaic industry status and future prospects of the development of photovoltaic industry. In the second chapter describes the basic p