注塑零件多指标优化方法研究及应用.pdfVIP

塑料工业 ??42????6?? CHINA ???? ???? 2014??6?? 注塑零件多指标优化方法研究及应用术 ??????1??????1??????2??????1????????1 ?．贵州大学机械工程学院材料成型及控制研究所，贵州贵阳???； 2??????????????????061??????????????550025) 摘要：针对塑件在成型过程中的多指标优化问题，利用注塑仿真软件对塑件进行仿真，预测其翘曲、体积收缩以 及缩痕效果，并结合正交试验、极差分析和综合评分方法对注塑工艺参数进行优化。结果证明，当模具温度为?℃， 熔体温度为??妫?Ｑ寡沽ξW⑸溲沽Φ??％，冷却时间为? s????????????20??⑸涫奔湮? S???????????? 综合质量较好，注射时间对综合评分影响最大。 关键词：注塑成型；仿真；多指标优化；极差分析；正交试验 DOI??10??3969??j??issn??1005??5770??2014??06??016 ????????????TQ320??66??TP391??9????????????B文章编号：??—??????—??—? The ???? and Application ? Multi??target?????? ? Injection Parts ?? Xi-kui????MEIYil??TIAN??，? ??琇? Bi??lil (I??Institute? ???? Forming and Control??School? ????? Engineering ? Guizhou University??Guiyang550025??China?? ?瓹?? Aerospace Science and ???? Group 061 Base??Guiyang???，??? Abstract??According? the ???? ? multi??target?????? ? injection ????瑃? injection molding ????? ???? was ?? ? ???? the ???? part??andthe warping effect??the??? shrinkage and the ??? ?? ?? predicted ? ????? ???? the ????? test??therange ???? ??? and the comprehensive ????? ? ???? the injection molding process parameters??Theresults ??? ?? ?? the ?? temperature was 50????the?? temperature was ??妫瑃? holding ???? for 1 ?％? the injection pressure??thecooling ?? for 1 5 ?瑃? holding ?? for ? ?琣? the injection ?? was 3 ?瑃? comprehensive quality ? the plastic ?? was better??theinjection ?? had the ???? ??? ? the comprehensive ?????．