Han skull rock cone temporal bone CT measurement of.docVIP

 PAGE \* MERGEFORMAT 3 Han skull rock cone temporal bone CT measurement of [Abstract] Objective: rock by measuring the Han cone anatomy of the skull for skull against the Han Chinese rock cone X-projection technology to provide a basis. Methods: Conventional head CT in the database, select the 242 cases of normal and non-deformed samples was measured with the SSD reconstruction of the skull rock cone and the angle between the midline and for statistical analysis. Results: The temporal bone petrous part of the standard projection axial location and the map described in the 45-degree varied significantly. Conclusion: The head of petrous bone axial projection technology should be based on rock cone and the midline sagittal angle between 55 degrees ± 5 degrees designed to be more appropriate. [Keywords:] covering the surface rock cone spiral CT reconstruction (SSD) measure X ray projection measurement technology in 1931 by Broadbent and Hofrath separately proposed, and since then, X ray projection technology has been the orthopedic field of the normal Department of Dental and Craniofacial morphology, structure of the important means of [1]. Exists between the different ethnic skull shape and structure of the difference. This study of 242 cases of normal head CT scan Han Chinese samples, the use of the surface coverage of the reconstruction (SSD) technology, Han Yan cone morphology of the skull measurements. 1 Data and methods 1.1 General Information Routine CT examination in the near future a database, randomly selected 242 cases of adult Han normal skull CT data. Required position is right and left sides symmetrical head shape without deformity, intracranial lesions without the more serious and substantial. 143 cases were male, female 99 cases, aged 19 to 80 years. All the samples were used SIEMENS Volum Zoom multi-slice spiral CT scans, scan parameters: 140 kV, 380 mA, collimation 5 mm, slice = 5 mm, pitch 4; reconstruction interval of 5 mm; Image Worksta