AC4遥控系统：参数和调整列表中英文说明讲述.doc

Introductions 绪言 There is two sets of parameters available in the AC4 remote control system. 在AC4遥控系统中有两套有用的参数。 This is SYSTEM OP.CODES and I/O CHANNELS. OP.CODES refers to SYSTEM PARAMETERS while I/O CHANNELS refers to the input and output signals for the system,for calibration and checking of this. I/O channel number are shown on the wiring diagram. 这是系统代码和输入/输出通道。对于校准和检查来说，当输入输出通道涉及到适合系统的输入和输出信号的时候，操作代码也涉及到系统参数。输入/输出通道数字将被出现在系统的配线图上。 On the control room unit,change between OP.CODES and I/O CHANNELS is done with pushbutton I/O COMMIS,when not pressed OP.CODES are obtained,when pushbutton are pressed and the indicators in this pushbutton lit,I/O channels are obtained. 在集控室单元，利用“I/O Commis.”按钮能够完成在操作代码和输入/输出通道之间进行切换，当不按压按钮时被得到是操作代码，当按钮被按压时在按钮内的指示器变亮，被得到的是输入输出通道。 On the bridge unit,change between OP.CODES and I/O CHANNELS is done with pushbutton COMMIS.LOCK,one press at this pushbutton,cause it to lit,and OP.CODES are obtained,when pushbutton are pressed twice,the pushbutton flickers and I/O channels are obtained. When pressed a third time,the pussbutton is extinguished,and panel is in normal operation mode. 在驾驶室单元，利用“Commis.Lock”按钮能够完成在操作代码及输入/输出通道之间进行切换，按压按钮一次，引起灯亮，同时被得到操作代码，当按钮被按压两次时，按钮将闪光同时被得到输入输出通道。按钮被按压三次时，按钮被熄灭熄灭，面板也进入正常工作模式。 As all parameters in this has a DEFAULT value,the field”adjusted” is only to be filled in when there are changes to the default value,this to easy reconfigurate the system after a EE prom failure.(You will only have to set the “ADJUSTED” values,as the default values are inserted by the system.) 如在这的所有参数都有一个默认值，当默认值被改变时，“可调整的”的区域只有被填写，在EEPROM有故障后，这将容易重新配置系统。（你将只有必须去调整“ADJUSTED”的数值，同样通过系统默认值被插入。 List Of Contents 内容目录 1、Commond Description Of Parameters for I/O Channels  HYPERLINK \l 关于输入输出通道参数的指令描述 关于输入输出通道参数的常见描述 1.1、Parameters Obtained On Different Channel Type  HYPERLINK \l 参数从不同通道上得到 参数在不同通道类型上获得 1.2、Brief description about adjustable and readable parameters  HYPERLINK \l 关于可调整的和可读参数的简短描述 关于可调整的和可读参数的简短描述 2、Autoc