PFM restoration of the main reasons for failure.docVIP

 PAGE \* MERGEFORMAT 9 PFM restoration of the main reasons for failure [Abstract] Objective: To investigate the metal ceramic crown failures. Methods: 100 patients with 180 patient PFM cast restoration after the repair due to failure analysis, mechanical failure of a case of root fracture and casting core porcelain crown off and crack in 1. Results: The mechanical failure rate was 1.7%. Conclusion: The causes of the failure to be repaired due to the earlier cast in metal ceramic restorations, strictly controlled, choose the good, the design must be reasonable , prepared tooth technology to improve, modulus and other factors to be accurate, and actively deal with failure. [Key Words] metal ceramic crowns; failure; restored Failure Analysis PFM restoration is currently in clinical use of multiple porcelain fused to metal crown. Metal Porcelain Crowns can be divided into the metal edge of the concave type, straight type, bevel type, blade type, concave bevel type and shoulder slope type, the type and the last two the best combination of porcelain, and the wider clinical use [1]. PFM restorations because of its high strength, color fidelity, color stable and comfortable appearance, easy to wear, marginal seal of and good biocompatibility characteristics, so its most widely used clinically [2]. stomatology hospital since June 2008 were done since the casting porcelain Dental 180, to achieve a satisfactory result, now the failure of the main Reasons are as follows. 1 Clinical data 100 patients, male 64 cases, female 36 cases, a total of 180 cases, aged 19 to 77 years, mean age 30 years. Teeth anterior teeth 86 points, five premolars, molars after 21 and mandibular anterior teeth 55, 6 premolars, molars 7 after which the number of units of porcelain bridge length from 3 to 6 units of 65, 7 to 14 units 11. porcelain restorations, including crowns and bridge repair, including the crown canopy and the crown, fixed bridge, including single-ended and fixed b