PFM suitability of different design on the edge of the impact of.docVIP

 PAGE \* MERGEFORMAT 2 PFM suitability of different design on the edge of the impact of [Abstract] Objective To study the non-precious metal-ceramic crowns 4 different crown marginal edge of the production methods of their fitness effects. Methods in accordance with the underlying metal crown in labial edge of the crown in turn reduce the risk group of non-precious metals produced in four metal-ceramic crowns. Group 1: metal copings labial extension Zhijian Taiwan labial edge; Group 2: limited shoulder Taiwan and Central; Group 3: gingival end on the shoulder and the shaft wall inclination at the highest side, gradually migrating to 1 mm gingival side wall inclination with the axis at the neck with shoulder porcelain; Group 4: beyond the shoulder gingival side wall inclination with the axis at the highest side 1 mm at the neck with shoulder porcelain. Observation and analysis of samples in each group marginal fit. Results Group 3 and Group 4 samples of labial marginal fit better, Group 1 and Group 2 samples of the lingual marginal fit is better. Conclusion shoulder porcelain, metal-ceramic crown labial marginal fit better; did not use shoulder porcelain, metal-ceramic crown lingual marginal fit better (P amp;lt;0.05). [Keywords:] dental prosthesis design; crown (prosthesis); Metal Ceramic Alloys ABSTRACT: Objective To study the influence of the four different crown  margin producing methods of non  precious metal  ceramic crown on the marginal fidelity. Methods Four groups of the non  precious metal  ceramic crowns were fabricated according to the gradual reduction of the labial marginal types. There were ten specimens in each group. The marginal fidelity was investigated under the microcrope (40X) of the XTB  B type. Results The labial marginal fidelity of the Group 3 and Group 4 was better (P