基于CT图像的矿石颗粒堆积体孔隙结构三维量化表征和.pdfVIP

Trans. Nonferrous Met. Soc. China 24(2014) 833−838 3D characterization and analysis of pore structure of packed ore particle beds based on computed tomography images 1,2 2 2 3 Bao-hua YANG , Ai-xiang WU , Xiu-xiu MIAO , Jin-zhi LIU 1. Information Science and Engineering School, Hunan International Economics University, Changsha 410205, China; 2. Civil and Environment Engineering School, University of Science and Technology Beijing, Beijing 100083, China; 3. College of Information Technology, Shanghai Ocean University, Shanghai 201306, China Received 24 April 2013; accepted 9 August 2013 Abstract: Methods and procedures of three-dimensional (3D) characterization of the pore structure features in the packed ore particle bed are focused. X-ray computed tomography was applied to deriving the cross-sectional images of specimens with single particle size of 1−2, 2−3, 3−4, 4−5, 5−6, 6−7, 7−8, 8−9, 9−10 mm. Based on the in-house developed 3D image analysis programs using Matlab, the volume porosity, pore size distribution and degree of connectivity were calculated and analyzed in detail. The results indicate that the volume porosity, the mean diameter of pores and the effective pore size (d50) increase with the increasing of particle size. Lognormal distribution or Gauss distribution is mostly suitable to model the pore size distribution. The degree of connectivity investigated on the basis of cluster-labeling algorithm also increases with increasing the particle size approximately. Key words: packed ore particle bed; 3D pore structure; X-ray comp