基于等价采高理论的固体充填采煤沉陷预计.pdfVIP

Trans. Nonferrous Met. Soc. China 24(2014) 3302−3308 Subsidence prediction method based on equivalent mining height theory for solid backfilling mining Guang-li GUO1,2, Xiao-jun ZHU1,2, Jian-feng ZHA1,2, Qiang WANG1,2 1. Key Laboratory for Land Environment and Disaster Monitoring of the State Bureau of Surveying and Mapping, China University of Mining and Technology, Xuzhou 221116, China; 2. Jiangsu Key Laboratory of Resources and Environmental Information Engineering, China University of Mining and Technology, Xuzhou 221116, China Received 10 July 2013; accepted 6 January 2014 Abstract: Based on the characteristics of strata movement of solid backfilling mining technology, the surface subsidence prediction method based on the equivalent mining height theory was proposed, and the parameters selection guideline of this method was also described. While comparing the parameters of caving mining with equivalent height, the subsidence efficient can be calculated according to the mining height and bulk factor of sagging zone and fracture zone, the tangent of main influence angle of solid backfilling mining is reduced by 0.2−0.5 (while it cannot be less than 1.0). For sake of safety, offset of the inflection point is set to zero, and other parameters, such as horizontal movement coefficient and main propagation angle are equal to the corresponding parameters of caving mining with equivalent height. In the last part, a case study of solid backfilling mining subsidence prediction was described. The results show the applicability of this method and the difference of the maximum