Analysis of the Manufactured Tolerances with the Three-Dimensional Method of Angular Chains of Dimensions Applied to a Cylinder Head of Car Engine英文文献资料.docVIP

Engineering, 2010, 2, 771-779 doi:10.4236/eng.2010.210099 Published Online October 2010 (http://www.SciRP.org/journal/eng) Analysis of the Manufactured Tolerances with the Three-Dimensional Method of Angular Chains of Dimensions Applied to a Cylinder Head of Car Engine Aida Mezghani , Alain Bellacicco , Jamel Louati , Alain Rivière , Mohamed Haddar 1,2 2 1 2 1 1 Mechanics Modelling and Production Research Unit, ENIS, TUNISIA 2 Laboratoire d’Ingénierie des Structures Mécaniques et des Matériaux, SUPMECA Paris, FRANCE E-mail: mezghani_aida@yahoo.fr Received May 4, 2010; revised July 21, 2010; accepted August 16, 2010 Abstract This paper proposes an analysis method of the manufactured tolerances applied to a cylinder head of car en- gine. This method allows to determine the manufacturing tolerances in the case of angular chains of dimen- sions and to check its correspondence with the functional tolerances. The objective of this work is to analyze two parameterized functions: the angular defect Δα and the projected length lg of the toleranced surface. The angular defects are determined from the precision of the machine tools, we consider only the geometrical defects (position and orientation of surfaces), making the assumption that the form defects are negligible. The manufactured defect is determined from these two parameterized functions. Then it will be compared with the functional condition in order to check if the selected machining range allows, at end of the manu- facturing process, to give a suitable part. Keywords: Three-Dimensional Tolerancing, Manufacturing Process, Toleranced Surface, Angular Defect. 1. Introduction proaches as Variational geometry [6,7], Vectorial toler- ancing [8,9], Clearance space and deviation space [10- 13], Gap space [14], quantifier approac