油漆工程施工工艺及验收标准.docVIP

  • 53
  • 0
  • 约3.89万字
  • 约 3页
  • 2017-05-16 发布于贵州
  • 举报
油漆工程施工工艺及验收标准

油漆工程施工工艺及验收标准 油漆工程施工工艺及验收标准提要:油漆涂刷前,应进行成品保护,将门合页、锁具、门边线边等易污染部分用纸胶带仔细粘贴。油漆饰面板上严禁堆放其它物品。 于房地产E网 油漆工程施工工艺及验收标准 工艺流程: 1、油漆必须选用优质漆品。施工时,清洁现场,尽量减少人员活动及有粉尘工序进行。 2、检查清理基层,可用400#砂纸轻轻打磨表面毛刺,用干净毛巾清洁,检查面板表面有无污迹、破损方能使用。 3、所有面板及线条均应在做了透明腻子及一遍底漆后方能使用。基材清洁后,上透明腻子,根据面板类型,可刷涂或直接刮涂,透明腻子刮涂2次,涂好4小时干后打磨,腻子以薄而均匀为好。 4、腻子打磨后,上透明底漆,透明底漆和特清透明底与固化剂、稀释剂的配合比 1::~1。透明底漆使用前用200#滤网过滤后刷涂或喷涂,涂刷2次。涂好4小时干后用400#砂纸打磨光洁备用。 5、油漆涂刷前,应进行成品保护,将门合页、锁具、门边线边等易污染部分用纸胶带仔细粘贴。油漆饰面板上严禁堆放其它物品。油漆物品下成品地面纸板保护,防止油漆滴落在成品地面。 6、施工时,油漆与固化剂、稀释剂配合比例详油漆施工说明。配漆后用200#以上滤网过滤,静置15分钟后使用。涂刷应薄而均匀,无流坠、针孔及漏刷部分。 7、填补钉眼,调出至少4色腻子后在样板试色。上面漆涂刷1遍。确定效果良好后使用。(50㎝远应不见明显钉眼),填钉眼时,注意检查木作工序缺陷部分,加以处理。 8、采用喷涂工艺时,应清理现场,地面应少量喷水防尘,喷涂均匀。 验收标准: 1、手感光滑、无颗粒感。 2、漆面饱和。 3、光泽合适、(清面漆清亮、透明度高)。 4、无流坠、刷痕。 5、对其它工种无污染。 6、清漆基层无污染。 7、混油基层平整、光滑,无挡手感。 8、透底有色漆施工色彩、深浅均匀一致。 于房地产E网 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustwort

文档评论(0)

1亿VIP精品文档

相关文档