粉末注射成形催化脱脂工艺研究.pdfVIP

学兔兔 第19卷第2期 粉 末 冶 金 工 业 V01．19 No．2 2009年 4月 p0WDER METALLURGY INDUSTRY Apr．2009 粉末注射成形催化脱脂工艺研究 郑礼清。李笃信。李 昆，赵 莉，王田军，白 锋 (中南大学粉末冶金国家重点实验室，湖南 长沙 410083) 摘 要：催化脱脂具有脱脂缺陷少，脱脂速率快等优点，是目前MIM技术领域新的发展方向。 采用三组不同配比的新型催化脱脂型粘结剂，研究了注射成形催化脱脂工艺中催化气体流量、 脱脂温度、脱脂时间对坯块脱脂率的影响。结果表明：试样F2具有较高的催化脱脂率和较好 的脱脂质量；采用HNO。催化气体通入速度为0．050mL／min对该试样在120℃进行催化脱 脂，经过5 h可基本脱除POM，脱脂率达到88．5 ，已经形成完成连通的孔道。 关键词：粉末注射成形；催化脱脂型粘结剂；催化脱脂 中图分类号：TF124 文献标识码：A 文章编号：1006—6543(2009)02—0032—04 CATALYTIC DEBINDING FOR POWDER INJECTION MOLDING ZHENG Li-qing。LI Du-xin。LI Kun，ZHAO li，WANG Tian~un，BAI feng (The State Key Laboratory for Powder Metallurgy，Central South University，Changsha 4 1 0083。China) Abstract：The catalytic debinding is a new technique Of metal inj ection molding(MIM)due to it’S inherent advantages—less flaws，and time consumed．Three different newly catalytic debinding binders were studied．Effects of catalytic gas flow rate，debinding temperature， debinding time on binder removal were investigated．The results indicated that according to the catalytic debinding rate and debinding quality sample F2 was the best，POM was removed basically，the debinding rate reached 88．5 and open pore channels were formed when the sample F2 was immersed in nitric acid atmosphere for 5 h at 1 20~C，with a nitric acid feed rate of 0．005mL／min． Key words：powder inj ection molding；catalytic debinding binder；catalytic debinding 粉末注射成形(PIM)具有一次成形复杂形状 热脱脂工艺其脱脂速度慢、易产生缺陷、只适合于小 制品、产品尺寸精度高、无需机械加工或只需