路面基层施工方法.docVIP

路面基层施工方法 路面基层施工方法提要：用轮胎压路机在已初平的路段上快速碾压一遍，以暴露潜在的不平整，再用平地机进行整平和整形。整形后，当混合料的含水量等于或略大于最佳含水量时，立即用振动压路机进行碾压 路面基层施工方法 完成整平后，施工队即可对检验合格的路段进行基层的施工，分层堆料，平地机摊铺，压路机碾压，洒水车洒水养护的一条龙进行作业。施工中必须严格控制颗料的级配和均匀性、摊铺料的厚度、平整度和压实度，并及时做好养生工作。 1、施工放样 （1）恢复中线。直线段每15～20m设一桩，平曲线段每10～15m设一桩，并在两侧肩边缘外～设指示桩。 （2）进行水平测量，在两侧指示桩上用明显标记标出底基层边缘的设计高。 3、备料 选择级配符合设计要求的材料，均匀层按松铺厚度堆放。 4、摊铺 用平地机将料按松铺厚度均匀地摊铺在预定的宽度上，表面应力求平整，并具有规定的路拱。设三人小组跟在平地机后面，及时消除粗细集料离析现象。对于粗集料窝和粗集料带，应添加细集料，并拌和均匀；对于细集料窝，应添加粗集料，并拌和均匀。 5、定型和碾压 用轮胎压路机在已初平的路段上快速碾压一遍，以暴露潜在的不平整，再用平地机进行整平和整形。整形后，当混合料的含水量等于或略大于最佳含水量时，立即用振动压路机进行碾压。直线段，由两侧路肩开始向路中心碾压；在有超高的路段上，由内侧路肩向外侧路肩进行碾压。碾压时，后轮应重叠1/2轮宽；后轮必须超过两段的缝外。后轮压完路面全宽时，即为一遍。碾压一直进行到要求的密实度为止，一般需碾压6～～8遍，应使表面无明显轮迹。压路机的碾压速度，头两遍以采用～/h为宜，以后用～/h。路面的两侧，应多压2～3遍。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quali