异步轧制铜铝双金属复合板变形行为的研究.pdfVIP

东北大学学报(自然科学版) 第 32卷第5期 Vo1. 32 ,No.5 2011 年 5 月 Journal of Northeastem University(Natural Science) May 2011 异步轧制铜/铝双金属复合板变形行为的研究 祖国现，李小兵，丁明明，于九明 (东北大学材料与冶金学院，辽宁沈阳 110819) 摘 堕:采用界步轧制复合工艺制备了铜/铝双金属复合板，分析了轧制工艺参数对复合板变形行为的 影响.结合轧制变形IKí%:阀受力状态探讨了复合过稳中的金属变形及流动规律.结果表明:界步轧制变形眼内 界面摩擦剪切作用自接影响母材的受力状态，共同变形区内双金属间的搓轧作用对金属流动及结合效果影 响最大.异~速比越大，硬质金属变形越大.总压下率增大时，组站金属脱下率均盟正比关系增加，且软、使两 种金属的压下事~值越来越小. 关键询:异步轧制;锢/铝复合板:异步速比;受力状态;变形行为 中固分类哥哥: TG 335.81 文献标志码:A 文章编号: 1005-3026(2011 )05-0675-04 Investigating Deformation Behavior of Asymmetrically Rolled CulAl Bimetal Clad Sheets ZU Cu(J←yi悦 ， LI Xiαφbing ， DING Min去ming ， YU ]iu-ming (hoolof Materials Metallurgy , Northeastern Urúversity, Sheny创19 110819, China. corre咿mditlg author: W Guo-yin , a础:x:iat巳 prof，创酬，巳mail: 四即@ snun. neu. edu. cn) Abstract: 丁he effect of roll bonding p盯ameters on defonnation distribution of CulAl bímetal clad sheets fabricated by asymmetrical roll bondíng was inv制ígated. The stress state of the defonnation zone w础 developed and used to analyze metal flow during the roll bonding proce盹 The defonnation proportion of hard comç盯nent metal in the whole clad sheet increas时制 asynchronous speed ratio increased. Shear friction directly impacted the str四s state of 协dy metals, and cross shear had the most influence on metal flow and bonding strength. The reduction of both layers was directly proportional to total reduction , and the difference between hard and 80ft metals gradually dimini咄咄. Key wo时S: a~ymmetrical roll; Cu/Al clad sheetj asynchronous speed ratioj stress statej defonnation behavior 铜/铝复合板、钢/销复合板等层状双金属复 实用价值与理论意义. 合材料在保持母材金属特性的同时还具有相补 异步轧制过程中轧辘绒速度不间，变形区