边坡柔性加固系统设计计算原理和方法.pdfVIP

第 25 卷 第 2 期 岩石力学与工程学报 Vol.25 No.2 2006 年 2 月 Chinese Journal of Rock Mechanics and Engineering Feb. ，2006 边坡柔性加固系统设计计算原理与方法 阳友奎 (布鲁克(成都)工程有限公司，四川 成都 611731) 摘要：根据边坡柔性主动加固系统的作用模式和莫尔–库仑破坏准则、极限平衡原理，修正并完善了以高强度钢 丝格栅和锚杆所构成的 GTC 型边坡柔性主动加固系统的作用原理，建立了系统的安全性检算条件和承载能力指标 的确定方法，提出了不同条件下锚杆锚固力要求的确定方法，从而完善了系统的设计计算原理和方法体系。 关键词：边坡工程；边坡加固；柔性防护系统；高强度钢丝格栅；作用原理；设计方法 中图分类号：P 642.22 文献标识码：A 文章编号：1000 –6915(2006)02 –0217 –09 CONCEPTS AND METHOD OF SLOPE FLEXIBLE STABILIZATION SYSTEM YANG You-kui (Geobrugg Chengdu Co.，Ltd. ，Chengdu，Sichuan 611731，China) Abstract ：There are some obvious errors and incompleteness in the existing(available) dimensioning concept of GTC flexible slope stabilization systems made of high-strength steel wire mesh in combination with anchor bolt. First ，the forces on the mesh resulting from partial instabilities are treated as two independent forces that can′t be mathematically determined because only one equilibrium equation for them can be formulated. One of the two forces has to be artificially assumed. Second，the longitudinal tensile force of the mesh is assumed as only transmitting to the upper nail ；that is ，the ability of the GTC flexible system transmitting force all around is neglected. The force concentration degree of the mesh at the upper nail is overestimated ；and the dimensioning results are too conservative. Third ，the existing concept doesn′t consider the determination of the lowest force against pull-out of nail. In view of this s