考验音质的六个参数(国外英文资料).docVIP

考验音质的六个参数 Test sound quality six parameters The sound quality of an MP3 player has never been measured by a quantitative metric, because the use of headphones and the users difference makes it different for an MP3 player. However, there were six measurable parameters that were able to reflect the quality of the sound quality, excluding subjective factors and external disturbances. Frequency Response: the wider the range, the better. Reflect the players play every frequency of sound signals of relative size whether also can keep the original form, ideally frequency response curve should be a straight line. A good frequency response is the ability to output stable enough signals at each frequency point, the same as the signal size of each other. At low frequencies and high frequencies, however, the reconstruction of the signal is difficult, so there is usually a decay in both frequencies. Output quality more good device, the better the frequency response curve flat, and not only at high frequency and low frequency attenuation soon, range in general may also appear dithering phenomenon. Noise level (background Noise) : the smaller the range, the better Noise level is in the process of signal processing to produce Noise signal and has nothing to do with the input signal, the lower the Noise value is, the better, of course, from low frequency to high frequency, the lower the location, the smaller the breadth, the result is better. Refers to the cause of the MP3 itself and to add extra signals in the output signal, and the system circuit design, anti-interference ability, and degree of isolation level before and after are directly related. Dynamic range (Dynamic range) : the wider the range, the better. Testing is not biggest distortion signal and the noise value, the proportion of the noise here is no signal output noise value, the greater the value of dynamic range, the better. Audio industry used to 60 db to test this value, because the output volume is close to full