WC-高铬铸铁铸渗层的组织与性能研究.pdfVIP

学兔兔 铸 造 Feb．2O11 · l92· FOUNDRY VOI．6O NO．2 WC一高铬铸铁铸渗层的组织与性能研究 王书利1,2王爱琴 ，谢敬佩 ，王文焱 (1．河南科技大学材料科学与工程学院，河南洛阳471003； 2．河南省有色金属材料科学与加工技术重点实验室，河南洛阳471003) 摘要：利用铸渗工艺在zG3ocr钢表面获得wc颗粒与高铬铸铁的铸渗层，通过改变涂覆层厚度，研究了铸渗层的组织 性能。结果表明：4％的硼砂作熔剂，4％的酚醛树脂作粘结剂，涂敷层厚度为5 mm 铸型，浇注温度控制在1 650℃左 右的条件下，铸渗层组织致密，无气孔、夹渣等缺陷，渗层与基体间为冶金结合，表面最大硬度可达Hv820，铸渗层 厚度为8-9InlTl。 关键词：铸渗；组织与性能；工艺参数；涂覆层厚度 中图分类号：TG142．72 文献标识码：A 文章编号：1001—4977(2011)02～0192—03 Microstructures and Properties of WC Reinforced High Chr0mium Iron Cast—Infiltrated Layer WANG Shu—li’I ，WANG Ai—qin’，XIE Jing—pei’，WANG Wen—yan’ (1．College of Materials Science and Engineering．Henan University of Science and Technology Luoyang 471 003，Henan，China；2．Henan Key Laboratory of Advanced Non—ferrous Metals， Luoyang 471 003，Henan，China) Abstract：The cast—infiltrated layer with WC particles and high chrOmium iron can be achieved on surface of ZG30Cr steel by cast-infiltration process．By changing the thickness of coating Iayer。the micrOstructure and properties of the cast—infiltrated layer were studied．The results show that the dense cast—infiltrated layer without pores，slags or other defects can be obtained under foIlowing conditions：4％ phenolic resin as binder，4％ borax as flux，coating thickness 5 mm and pouring temperature about 1 650℃．The bond between cast—infiltrated fayer and substrate iS metallurgical bond。the maximum SUrface hardness iS nearly Hv820 and the thickness of the ca