单辊法制备Fe26.8Co11Ni57.6Si0.81B3.79声磁标签用非晶合金.pdfVIP

学兔兔 Oct．2015 Vo1．64 NO．1O 单辊法制备Fe26．8Co 1 N i57_6Si0_81 B3．79声磁标签 用非晶合金 邓 燕，王慧敏，裴文利，刘 铁，杜宁宇，王 强 (东北大学材料电磁过程研究教育部重点实验室，辽宁沈阳110819) 摘要：利用单辊熔融快淬法制备了Fe co。。N s B] 声磁标签用非晶合金薄带，研究了铜辊转速、喷嘴至铜辊表 面距离和氮气喷压三个参数对Fe 8Co Ni Si B 合金薄带厚度、表面质量和显微组织的影响。结果表明，铜辊转 速、喷嘴至铜辊表面距离和氮气喷压对薄带厚度有重要影响。在较高转速下，薄带为完全的非晶态，随着铜辊转速 降低，开始出现晶化现象；在较小嘴距下，薄带是完全的非晶态，随着嘴距的增加，薄带明显晶化；在较低氮气喷 压下，薄带为完全的非晶态，随着喷压增加，薄带出现晶化。在铜辊转速为1 800 rpm，喷嘴至铜辊表面距离为 0．1 min和氮气喷压为0．05 MPa情况下制得的薄带响应距离最远为25 mm。 关键词：单辊熔融快淬；声磁标签；共振片；非晶合金；响应距离；磁性能 中图分类号：TG139+．8 文献标识码：A 文章编号：1001—4977(2015)10—1017—05 Fabrication of Fe260ollNi57Si0B379 Amorphous Alloy Used in ．8 ．6 ． 81 ． Magneto--Acoustic Marker by Single--Roller Casting Technique DENG Yan，WANG Hui-min，PEI Wen·li，LIU Tie，DU Ning-yu，WANG Qiang (Key Laboratory ofElectromagnetic Processing ofMaterials(Ministry ofEducation)，Northeastem University， Shenyang 1 1 08 1 9，Liaoning，China) Abstract：Amorphous ribbons ofFe268Co11Ni57~Si㈣B3_79 used in magneto—acoustic marker were fabricated with single．roller melt．spinning technique．The effect of the rotation rate of roller,distance between nozzle and copper roller,and nitrogen injection pressure on the thickness，surface quality and microstructure ofamorphous ribbons were studied．It was found that the rotating rate ofroller，distance between nozzle and copper roller,and nitrogen iniection pressure exhibit obvious effects on the thickness ofamorphous ribbons．The ribbon shows an amorphous structure at high rotating rate．small distance between nozzle and copper roller and low nitrogen injection pressure．However,the ribbon tends to crystallize with decreasing rotating rate，inc