Workover Rig_SL120hose 修井机.pptVIP

SL120 Swivel 水龙头 SL120 Swivel水龙头提纲 Ⅰ Technical Specifications 主参数 Ⅱ Assembly Drawing 结构总图 Ⅲ Structure Explanations结构说明 Ⅳ Operating Instructions使用说明 Ⅴ Assembling Procedure总装装配过程 Ⅵ Assembling Instructions总装装配注意事项 Ⅶ Typical Parts Machining Process典型零件的加工工艺 Ⅷ Maintenances维修与保养 Ⅸ Vulnerable parts List易损件清单 Ⅱ Assembly Drawing结构总图 Ⅲ Structure Explanations结构说明 SL120 swivel mainly consists of bail,body,bonnet,bearing cover,gooseneck,shock absorber assembly,stem and wash pipe packing,etc.SL120水龙头主要由提环，壳体，外罩，轴承盖，鹅颈管，减震器总成，芯轴以及冲管盘根装置等组成。 Bail is connected to the body with two bail pins.It hangs the swivel to the traveling block.提环由两个提环销与壳体连接，它使水龙头悬挂在大钩上。 The body is installed with main bearing which can carry all weight of drilling string, upper and lower alignment bearings,one ball thrust bearing.壳体内装有承受全部钻柱重量的主轴承，上、下两个定位轴承，以及一个推力球轴承轴承。 There is a screw hole on the bonnet used to fill oil to the swivel body.On the other side of the bonnet there is a breathing hole used to automatically discharge the high pressure air arised in the body.外罩上加工有一个螺孔，用它可向水龙头壳体内加油。外罩另一侧加工有一通气螺孔，当水龙头壳体内产生气压时，就会从此孔自动排出。 Ⅳ Operating Instructions使用说明 SL120 is load and dynamic pressure tested before shipment.In shipment, the swivel should not have oil inside.So the followings must be conducted: SL120水龙头出厂前已进行负载和动压试验，出厂时，水龙 头壳体内是无油的，因此，在使用前必须做到： 1、Unscrew the plug and fill 19 liters 11# diesel engine oil,the oil must be clean; Install the vent valve in the breathing hole. 拧下堵头装入19升11号柴油机油，在通气孔中装上透气塞。保证油质洁净； 2、Check the stem to see that it can rotate freely and evenly by a one meter long chain wrench . 检查芯轴，由一个施力于1米长的链钳手柄上，能均匀转动； 3、Use oil gun to fill all oil cups. 用油枪润滑各油杯； 4、Check the upper and lower seal nuts of packing assembly for tightness. 检查盘根装置上下密封螺母等处是否上紧。 Ⅴ SL120 Swivel Assembling Procedure 水龙头的总装装配过程 1、Prepare all parts and assemble them in accordance with drawing.按图备齐各件、清理、组装。 2、Fill the oil and grease.加注黄油，机油。 3、Assembly is high pressure and leakage tested.