汽车音响有杂音如何办(国外英文资料).docVIP

汽车音响有杂音怎么办(国外英文资料) What about the noise of the car stereo How should noise noise be handled when the car stereo is modified? Heres how the noise goes into your stereo system, how to determine and resolve the noise. Firstly, according to the noise situation, the fault area is identified by principle analysis and judgment. Noise tends to intruder into your sound system. A, enter the power line (through the host and the power line into the system). B, the current through the geodesic (through the ground line of the antenna and the ground line of the power). C, interference from other wires (via antenna reception and the interference of the original line) D, use other electrical interference (electric horn, generator, etc.). Second, the countermeasure of noise Noise in general use parts, car audio capacitor (especially effective to cope with the high frequency noise, the flow of urban circle (inductance), filter, ground wire, etc., to deal with ignition system produced by the noise. 1, check whether the positive to the ignition coil capacitor installation, if capacity reducing platinum contact easy ablation, the disturbance spark, need to replace the electric capacity of O, 5 uf / 400 v non-polar capacitors, use carbon line to check whether the high tension line ignition, prone to interference if using wire type, by its is radio interference is serious, so it must be replaced. It is possible to use the method of increasing resistance of the resistance, to make the spark noise, and the method is to use one megabit resistance string to the ignition coil to output the main high voltage line, reducing the interference. The removal of motor noise Will first car audio modification of equipment and signal lines away from the motor and motor line, available 1 non-polar capacitors in parallel on both ends of the motor only, also can use first two inductance in series across the electrodes in the motor line respectively, with two non-polar capacitor across the electrodes in the