混凝土工程工程量计算(国外英文资料).docVIP

混凝土工程工程量计算(国外英文资料) Chapter v construction of concrete instructions The concrete components of this chapter are divided into three parts: self-mixing concrete parts, concrete pump parts and non-pump parts The parts include the present water casting, the site prefabrication, the prefabrication of the processing plant, the structure and so on. 2, the concrete stone grain is determined: the design has the regulation according to the design, no design regulation presses the table regulation to calculate: Pebble grain of the Component name 5 ~ 16 mm Prefabricated parts and prefabricated small components 5-31.5 mm Casting member: rectangular column (except for the column of composition), cylinder, polygon column (L, T, + column except), frame Beam, single beam, continuous beam, basement waterproof concrete wall Precast member: column, beam, pile 5 ~ 20 mm All of the above components are used in this particle size. 5 ~ 40 mm Basic bedding, various foundations, roads, retaining walls, basement walls, large concrete Note: this regulation also applies to other parts. The amount of gross stone in the rubble concrete is calculated by 15%, if not at the same time, the ratio of the amount of rubble and concrete can be reduced to the other. Four, the present water column, the inside of the wall of the inside of the wall is all according to the regulation to consider the bottom to set the dosage of the cement mortar. The artificial days of the column, beams, walls, and plates (all kinds of plates), which are more than 8m high, are multiplied by the following coefficients: the net height is 1.18 in 12m. The net height is 1.25 in 18m. The on-site prefabricated components, such as the fabrication of the processing plant, the concrete mixing ratio is calculated according to the processing plant. The processing plant and the concrete are made in the field. No adjustment of the construction and machinery. Seven, processing components, other materials have been considered the cost of addin