双向板按弹性方法照样按塑性方法计算(国外英文资料).docVIP

双向板按弹性方法还是按塑性方法计算(国外英文资料) The bi-directional plate is calculated by elastic method or by plastic method Hello, miss MAO! Would like to ask you a question, PKPM are generally calculate by elastic calculation of bidirectional board, but when I was last year into the design institute has a project is calculate by plastic, this influence is not big, bearing and bending moment ratio coefficient obtained in across the default 1.8? I am looking forward to your reply! The method of structural analysis should meet the three basic equations, namely mechanical equilibrium equation, deformation coordination (geometry) condition and constitutive (physical) relation. The importance of this is also sorted. The mechanical balance must be satisfied, the deformation coordination should be satisfied, and the constitutive relation can be chosen rationally. The elastic deformation is the deformation of the material when it is acted upon by the external forces, and the deformation is elastic. The plastic deformation material produces irreversible permanent deformation under the action of external forces. The method of elastic analysis is the most basic and mature structure analysis method, and also the basis and special case of other analytical methods. It is a method of hypothesis and simplification, regardless of the discrete and nonlinear properties of the material. It applies to the general structure. The analysis method of plastic internal force redistribution is used in the design of ultra-static concrete structure. The elastic-plastic analysis method is based on the actual mechanical properties of reinforced concrete, considering the internal force redistribution of plastic deformation. By introducing the corresponding constitutive relationship, the analysis of the structural stress can be carried out, and the analysis of the complex structure of various types and forces can be solved successfully. According to the specification requirement: The bi-directional plate is calculated