ansys使用手册(国外英文资料).docVIP

ansys使用手册(国外英文资料) Chapter 11 creates the geometry display 11.1 shows the geometry in a GUI Geometric display is the geometric feature of the model (key points, surfaces, nodes, units, loads, etc.). This display mainly occurs during the analysis phase during the generation and load definition of the model. Figure 11-1 shows a typical geometric display. Figure 11-1 a typical geometric display Many users find and control the geometry shows the easiest way is to use the Utility Menu the Plot and the Utility Menu Plotctrls under the function of the item, in addition, still can use the following paragraph of graphics and control command. Create the display of the entity model entity The following command creates the display of the entity model entity The command The GUI menu path use APLOT MainMenu Preprocessor , Show Degeneracy Plot Degen Areas The Utility Menu Plot Areas UtilityMenu Plot Specified Entities Areas Display surface figure EPLOT The Utility Menu Plot Elements Display unit figure KPLOT The Utility Menu Plot Keypoints Utilitymenu Plot SpecifiedEntities Keypoints Show key points LAYPLOT UtilityMenu Plot Layered Elements The display layers heap order and layer unit type (such as SOLID46 and SHELL91) LPLOT The Utility Menu Plot Lines Utilitymenu Plot SpecifiedEntities Lines According to planNPLOT The Utility Menu Plot Nodes Figure shows node / KEPLOT The Utility Menu Plot Replot Execute the last display action VPLOT Mainmenu Preprocessor , Show Degeneracy Plot Degen VOLUS Display the degenerate body diagram Established before the trigger the action control can also contain other information, according to such as serial number number lower entities (such as entities associated with selected unit number), load, etc. 11.3 changes the description of the geometry In addition to the characteristics listed below, see chapter 8 for any type of common graphic specification that includes geometric display. 11.3.1 changes the display style The