KTGC-03.17-2008净化风管安装规程(国外英文资料).docVIP

KTGC-03.17-2008净化风管安装规程(国外英文资料) Jiangyin jingya group Air conditioning engineering company Engineering discipline of engineering department KTGC - 3.17-2008 To purify the air duct Make installation process specification Version of the time 01 A total of eight pages Page 8 The scope of application This procedure is suitable for the processing, manufacture and installation of purified metal wind pipe used in the ventilation and air conditioning project with purification requirements. Equipment and tools Ac arc welder, bench drilling machine, shearing machine, folding machine, nip machine, roll round machine, grinding wheel cutting machine, electric hammer, drill, wrench, chain blocks, hammer, square, square, protractor, compasses, tape measure, screwdriver, hand cut, die, etc. Three, preparation, Prepare the required tools to dust and clean the oil. Clean the work area, make sure the place is clean and clean, and use a thick 10mm rubber panel to cover the floor, then wash it with clean water. Check the quality certificate of the required materials, the complete quality guarantee and the quality of the product. Fourth, make The process flow of metal wind tube processing is as follows: an Line drawing shear blanking chamfering Bite to make Duct fold the side The molding Methods under the blue material welding Knockout punch Rolled round flange line blanking Leveling to find the whole Punchs a hole punch Riveting flange double edge check check Clean the sealing Anticorrosive oil brush Anticorrosive oil brush led material Skim clear wash 4.2 material The material varieties, specifications and thickness of the pipes shall conform to the design and the current national product standards. When the design is not specified, the zinc-plated steel plate, stainless steel plate or aluminum plate shall be chosen, and the thickness of galvanized steel plate shall be pressed according to the provisions of table 1. The thickness of the stainless steel plate is specified in table 2; Th