V型滤池(国外英文资料).docVIP

V型滤池(国外英文资料) Seven, v-shaped filter The main parameters are as follows Design water capacity Q = 147, 000 m3 / d The speed of the filter is 8m/h, which forces the filter to be 20m/h The filter rinse condition is shown below Flushing intensity (L/m2) Flushing time (min) First step. 15 3 Second step (air - water flush) air 15 4 water 5 Step 3 (water) 5 5 Always wash time 12 min Rinse cycle T = 48 h Recoil sweeping strength / 1.8 L (s. ㎡) (generally 1.4 ~ 2.0 L/(s. ㎡) The filter is made of single layer thickening, which is 0.96 ~ 1.35 mm, and the non-uniformity coefficient is 1.2 ~ 1.6 The design process is as follows. (1) pool design Filter work time (not considering discharge filtration) 2. The filter area F The filter pool To save floor, choose double lattice type filter, the pool bottom with concrete, single width B = 3.5 m, L single = 14 m long, the single area of 49 ㎡, divided into in two groups, each group of four, a total of eight, each area of 98 ㎡, with a total area of 784 ㎡ Check the speed of the check Meet the requirements. Determine the height of the filter Filter ultra high of 0.3 m The depth of the filter is 1.5 m Filter material thickness of 1.0 m Filter plate thickness of 0.13 m Height of 0.9 m (0.7 ~ 0.9) under the filter The total height H of the filter is 0.9 + 0.13 + 1.0 + 1.5 + 0.3 = 3.83 m Water wind well design Filter adopts single layer thickening are grain of filter material, particle size of 0.95 ~ 1.35 ㎜, non-uniform coefficient is 1.2 ~ 1.6 The water head loss of the clean filter layer is pressed Delta H - water flows through the cleaning layers head loss, cm V - the movement of water viscosity, c ㎡ / s; At 20 ℃ for 0.0101 ㎡ c/s; G -- the acceleration of gravity, 981 M0 - filter porosity; Take 0.5; D0 - the same as the filter material volume of a sphere diameter, ㎝, according to data provided by the manufacturer is 0.1 ㎝ L0 - filter layer thick 100 cm V - filtration velocity, ㎝ / s, v = 11 m/h = 0.31 ㎝ / s; The size of the filter pellets is