xx隧道斜井转入正洞施工方案2(国外英文资料).docVIP

xx隧道斜井转入正洞施工方案2(国外英文资料) The slope of the ramp is reinforced by 3 parallel I20a, which is supported by the hole steel frame. In order to ensure that the steel frame of the zhengdong hole is secured, the I20a steel girder is set up by the inclined well and the positive hole, and the torang is welded with 3 pieces of the I20a steel frame. The upright steel frame falls on the tori beam and welded together with the torliang, the arch space is 1 f / 1.0 m, processing 11. The beams of the intersection are arranged as follows. To connect the beam with the inclined shaft The arch of the steel frame of the hole is set up with the anchor pipe, and four (two) of four (two) of four (two) long, four meters of phi 42 lock anchor pipe are set to secure the arch. (3) slope longitudinal tie to the hole is 1 m, and is hole steel or longitudinal rod welding is firm, are inclined to reach hole lead small catheter with steel welding is hole (small catheter spare parts cut). (4) are deviated well and hole intersect between beam and steel using I16 steel support column welded together, I16 between steel support column distance of 1.0 m (with steel frame is hole spacing), steel on steel support is hole on the top on the beam, the concrete arrangement is as follows: The torang is connected to the steel frame and steel support. Connect the bridge to the steel frame of the bridge (3) strengthening the construction of the hole Fellowship with inclined hole is strengthen DK318 + 570 ~ DK318 + 630 section 60 m range, practical for Ⅱ level of surrounding rock, according to the design level of a reduced grade Ⅲ rubber-sealing belt of surrounding rock is adopted to improve the supporting, including slope fellowship with positive hole range from 1 m on each side add I20a steel support. Support parameters: DK318 + 597 ~ 1) is hole DK318 + 606 section range I20a steel frame, the span 1.0 m, with 22 longitudinal connection between steel bar welded together, tie rod ring to the spacing of 1 m, steel fra