实验5 比体积电阻、比表面电阻的测定(国外英文资料).docVIP

实验5 比体积电阻、比表面电阻的测定(国外英文资料) Experiment 5 ratio of volume resistance to surface resistance One, the purpose of the experiment A deeper understanding of the physical significance of a resistive force than a surface resistor. The use of insulation resistance tester (high resistance meter). Second, the experimental principle The surface resistance Rs is called the surface resistance Rs, which is applied between two electrodes and the dc voltage applied to the two electrodes and the current ratio of the sample surface layer of the sample surface of the electrode that flows through the electrode. If the sample length is 1cm and the sample width of the two electrodes is one centimeter, then the Rs is the ratio of the sample to the surface resistance rho s, the unit is ohm. In the same way, the ratio of the dc voltage to the two electric shocks and the current in the sample volume that flows through the electrode is called the volume resistance Rv. If the sample thickness is 1cm and the measuring electrode area is 1 square centimetre, then the Rv value will be the ratio of the volume resistance of the ocean to the volume resistance of rho v, and the unit is ohm cm. Usually, when referring to resistive without special mention, it means rho v. Rho s and rho v are measured by insulation resistance tester (ultra high resistance meter) and galvanometer method. The main principle of insulation resistance tester is shown in figure. During the test, the input resistance R0 series of the test sample Rx and the high impedance dc amplifier was connected to the dc high voltage test power supply. The amplifier outputs the partial pressure signal on the input resistance R0 to the indicating instrument CB, which can read the Rx value directly. The formula for this experiment is as follows: Rv = R0 Rho v is equal to Rv 3, Ae = (d1 + g) 2 = 21.237 (cm2) Type: Rv - volume resistance T - measured thickness (cm) D1 - measuring electrode diameter (5cm) G - measuring electrode clearance (0.2 cm