标准椭圆形封头的几何形状(国外英文资料).doc

标准椭圆形封头的几何形状(国外英文资料) The geometry, size and quality of the standard oval head (1) the geometric shape of the head Bus is to form the head by a quarter ellipse line and a short straight line parallel to the rotating shaft can be connected with the smooth, so the head is made from half ellipsoid and a highly h0 cylindrical nipple (call it the straight part of the head). The surface depth of the standard oval head is a ratio of 1 to 4. The nominal diameter of a straight edge is recommended in two sizes: when the nominal diameter is less than, equal to 2000mm, h0 = 25mm. H0 = 40mm when the nominal diameter of the DN is greater than 2000mm. (2) the formula for calculating the amount of head geometry and mass Ellipsoidal head calculation formula of geometrical quantity and quality of associated with four parameters, i.e., the long axis radius a, b, short shaft radius delta P straight highly h0 and steel plate thickness, the calculation type listed in table 1 below: A general formula for calculating the geometry and mass of the oval head The billet diameter The quality of billet Inner or outer surface area volume The quality of Note: 1. The unit length unit is m, the steel plate density unit is kg/m3. According to the need of a and b, the size of the diameter or the diameter of the diameter of the diameter of the diameter of a. For a standard oval head with internal diameter as a diameter, the calculation formula is listed below table 2. According to the formula shown in table 1, the elliptical head of any a and b value can be calculated by the numerical value of the geometry and mass. The geometrical quantity and mass calculation formula of the standard oval head project Accounting system Billet diameter D0 Billet quality G0 The surface Fi Volume V Head quality G Note: 1. All of the above is equal to 0.5 Di Di, b = 0.25 Di, which is exported by the general calculation formula of table 2. The head quality formula should be calculated according to the surface of the sealing