基于CAD的WGOTHIC几何建模方法研究和软件研发.pdf

Vol . 45 No . 1 计算机与数字工程 总第327期 176 Computer • Digital Engineering 2017年第1期 基 于 C A D 的 W G O TH IC 几何建模 方法研究和软件研发$ 王国忠张经瑜 (上海核工程研究设计院上海230033) 摘 要 在 使 用 W GOTHIC 程序进行反应堆安全壳压力响应分析时, 需要基于其输人格式建立几何模型。目前建立 过程通常是依据工程设计的二维图纸，通过人为空间想象和人工数学计算, 手动进行建模。这种建模方法一方面非常繁琐、 耗时耗力，另一方面存在大量保守的近似与简化。研究提出了一种基于计算机辅助设计(CAD)的 W GOTHIC 几何建模方 法。该方法利用现有用于工程设计的三维CAD 几何模型，采用计算机图形学原理和实体几何造型技术，建立工程CAD 几 何模型到W GOTHIC 几何模型的转换方法，自动构造W GOTHIC 计算所需几何模型。然后在此基础上研发了辅助建模软 件，并采用 CAP1000模型对方法和软件进行了验证。结果表明,该方法能够有效提高W GOTHIC 几何建模的效率。 关键词计算机辅助设计；热工水力；几何建模 中图分类号 TP391. 72 DOI ：10. 3969/j. issa 1672-9722. 2017. 01. 039 Research and Software Development of WGOTHIC Geometry Modeling Method Based on CAD WANG Guozhong ZHANG Jingyu (Shanghai Nuclear Engineering Research Design Institute, Shanghai 230033) Abstract It is necessary to model the geometry of WGOTHIC when using it to analyze the pressure response of the re­ actor containment. The present manually modeling method is based on the two-dimensional engineering design drawings, through the human space imagination and manual mathematical operations. This method is tedious ，time-consuming and a­ dopts some conservative approximation and simplification. A new modeling method for the WGOTHIC geometry based on Computer Aided Design (CAD) technology is proposed in this paper. The present three-dimensional CAD geometry model for engineering construction is utilized and a conversion method between engineering CAD geometry and WGOTHIC geome­ try is developed. This method is implemented as auxiliary modeling software. The verification res